Jenn-Air GAS WALL OVEN Use & Care Manual

Also see for GAS COOKTOP: Instructions Use & care guide Use & care guide Use and care guide Service manual

6O VEN C OOKINGBaking Notes:• To change the oven temperature during cooking, pressBake, then press the Autoset 0 or appropriate numberpads until the desired temperature is displayed.• To change the oven temperature during preheat, pressthe Bake pad twice, then press the Autoset 0 pad orappropriate number pads until the desired temperature isdisplayed.• If you forget to turn off the oven, it will automatically turnoff at the end of 12 hours. If you wish to deactivate thisfeature, see page 9.BakingTo set Bake:1. Press the Bake pad.• BAKE and 000 will flash in the display.2. Select the oven temperature. Press the Autoset 0 pad for350° F or the appropriate number pads.• Each additional press of the Autoset 0 pad will increasethe temperature by 25°.• The oven temperature can be set from 170° to 550°.3. Press Bake pad again or wait four seconds.• BAKE will stop flashing and light in the display.Baking Differences Between Your Oldand New OvenIt is normal to notice some baking time differences between anew oven and an old one. See “Adjusting the Oven Temperature”on page 10.• 100° or the actual oven temperature if over 100° F willdisplay. It will rise in 5° increments until the presettemperature is reached.4. Allow the oven to preheat for 8-15 minutes.• When the set oven temperature is reached, one longbeep will sound.• The set temperature will display.• To recall set temperature during preheat, press Bake pad.5. Place food in the oven.6. Check cooking progress at the minimum cooking time.Cook longer if needed.7. When cooking is finished, press CANCEL pad.8. Remove food from the oven.Cook & HoldWhen using the Cook & Hold option, the oven begins to heatimmediately after the control has been set. Then, the ovencooks for a specified length of time. When that time haselapsed, the oven will keep the food warm for up to an hourthen automatically turn off.To set Cook & Hold:1. Press the Cook & Hold pad.• HOLD will flash to indicate that you are in Cook &Hold programming.• 00:00 will flash in the display.2. Select the amount of time you want to cook by using thenumber pads.• HOLD continues to flash.• The time will light in the display.• Time can be set from 10 minutes (00:10) to11 hours, 59 minutes (11:59).3. Press the Bake pad and select the oventemperature. Press the Autoset 0 pad for 350° For the appropriate number pads.• BAKE will flash.• The oven temperature can be set from 170° F to 550° F.4. Press the Bake pad again OR wait four seconds.• BAKE will remain lit.• The cooking time will show in the display.• The actual oven temperature will be displayedduring preheat.• The set temperature will display when the oven ispreheated.When the cooking time has elapsed:• Four beeps will sound.• HOLD and WARM will light.• 170° will display.• Time of day will display.8112P336-60 8/10/06, 2:21 PM7