Jenn-Air JB36NXFXLW Installation Manual

Also see for JB36NXFXLW: Use and care guide Installation guide Installation guide Energy guide Manual

Contents

Jenn-Air JB36NXFXLW Installation Manual Manual pdf 20 page image

20NOTE: To achieve a flush installation, it is critical to verify a ³⁄₄"(1.9 cm) depth from the front face of the adjacent cabinetry tothe refrigerator.Level and Align RefrigeratorIMPORTANT: All four leveling legs must contact the floor tosupport and stabilize the full weight of refrigerator. Rollers are formoving refrigerator and not for permanent support.After moving the refrigerator to its final location:1. Use a ⁵⁄₁₆" socket driver to turn the leveling bolts clockwise toextend the legs to the floor as shown. The rollers should be offthe floor.2. Adjust the leveling legs to level and align the refrigerator fromleft to right and front to back so that the refrigerator is leveland aligned with the cabinets.3. Continue adjusting the leveling legs until the top of therefrigerator is making contact with the bottom of the solidsoffit, or the bottom of the anti-tip boards, if anti-tip boardswere used. Do not crush the compressor cover.IMPORTANT: Adjust in small increments to keep fromdamaging the cabinet trim and causing problems with thedoor alignment or top grille fit. To avoid damage to the cabinetor leveling legs, do not apply more than 50 inch-pounds(5.65 Nm) of torque to the leveling bolts. The leveling legs canbe extended to a maximum of 1¹⁄₄" (3.18 cm) below the rollers.4. After leveling the refrigerator, use a straight edge or 4-ft levelgoing across the front of the refrigerator installation to thecabinets to check that the refrigerator is still flush.Install Refrigerator and PanelsIMPORTANT: Jenn-Air is not responsible for the removal oraddition of molding or wood overlay panels that would not allowaccess to the refrigerator for service.Install Top Grille Filler (standard installation only)IMPORTANT: The grille panel height allows the necessary airflowfor refrigerator performance. The top grille filler hides the uppercompartment cover behind the top grille. If you choose to modifythe recommended grille panel dimensions, performance will becompromised.Custom Wood Panel Models1. In the custom made (1" x width of grille panel) wood fillerpiece, drill a hole ¹¹⁄₁₆" from each edge.NOTE: Make sure the hole is centered in the 1" thickness ofthe wood piece.2. Using slotted hex-head screws (provided with refrigerator),fasten an “L” bracket to each end of the wood filler piece.3. Using hex-head blunt screws (provided with refrigerator),attach the “L” brackets to the top grille mounting plates.A. Adjacent cabinet or wallB. Installation blockC. Face of refrigeratorA. Rear leveling boltB. Front leveling boltBCA³⁄₄" (1.9 cm)WARNINGTip Over HazardRefrigerator is top heavy and tips easily when notcompletely installed.Keep doors taped closed until refrigerator iscompletely installed.Use two or more people to move and installrefrigerator.Failure to do so can result in death or serious injury.A BABA. Two 2" x 4" x 32" (5 cm x 10 cm x 81 cm) boardsB. Attach to studs with six #8 x 3" (7.6 cm) screwsC. Compressor coverD. Distance from bottom of anti-tip boards to floorAB2" (5 cm)C84"(213.4 cm)D