Jenn-Air JB36SSFXLA Installation Manual

Also see for JB36SSFXLA: Use & care guide Energy guide

Contents

Jenn-Air JB36SSFXLA Installation Manual Manual pdf 19 page image

19Inset Installation Dimensions36" [91.4 cm] Models1. Measure the distance from point A (as shown) to the backwall. Add ¹⁄₃₂" (0.8 mm) to this measurement to allow the sidepanel to fit into the trim.2. If the panel is more than ³⁄₈" (9.5 mm) thick, rout the front edgeto allow the side panel to fit into the trim42" [106.7 cm] Models1. Measure the distance from point A (as shown) to the backwall. Add ¹⁄₃₂" (0.8 mm) to this measurement to allow the sidepanel to fit into the trim.2. If the panel is more than ³⁄₈" (9.5 mm) thick, rout the front edgeto allow the side panel to fit into the trim.Recessed Inset Installation Dimensions36" [91.4 cm] Models1. Measure the distance from point A (as shown) to back wall.2. Rout the front edge of the support board or attach a ³⁄₈"(9.5 mm) board to hold the panel in the cabinet side trim.42" [106.7 cm] Models1. Measure the distance from point A (as shown) to back wall.2. Rout the front edge of the support board or attach a ³⁄₈"(9.5 mm) board to hold the panel in the cabinet side trim.INSTALLATION INSTRUCTIONSUnpack the RefrigeratorIMPORTANT:■ Do not remove the film until the refrigerator is in its operatingposition.■ All four leveling legs must contact the floor to support andstabilize the full weight of the refrigerator.■ Keep the cardboard shipping piece or plywood under therefrigerator until it is installed in the operating position.1. Remove and save the literature package bag taped to the sideof the refrigerator and the parts bag behind the grille. Removethe four brackets (two on each side) that attach the shippingbase to the refrigerator bottom.NOTE: Do not remove tape and door bracing until therefrigerator is in its final location.2. If necessary, reduce the tipping radius. See “Tipping Radius”for ceiling height requirements or “Reduce Tipping Radius” forstep-by-step instructions. If you do not need to reduce thetipping radius, proceed to “Move the Refrigerator into House.”Reduce Tipping Radius(if required)Before bringing the refrigerator into the home, be sure there isadequate ceiling height to stand the refrigerator upright. See“Tipping Radius” in the “Installation Requirements” section formore information.If you do not have adequate ceiling height to stand the refrigeratorupright, the tipping radius can be reduced by removing the topgrille and side trims (see the following chart).1. Grasp both ends of the top grille.AAAAModel Reduced Tipping Radius36 88" (223.5 cm)42 88¹⁄₂" (224.8 cm)WARNINGTip Over HazardRefrigerator is top heavy and tips easily when notcompletely installed.Keep doors taped closed until refrigerator iscompletely installed.Use two or more people to move and installrefrigerator.Failure to do so can result in death or serious injury.