Jenn-Air JB36SSFXLA Installation Manual

Also see for JB36SSFXLA: Use & care guide Energy guide

Contents

Jenn-Air JB36SSFXLA Installation Manual Manual pdf 27 page image

27Install Base GrilleThere are two pieces to the base grille to allow for a custom fit: thebase grille itself and the skirt. The skirt can be added to the basegrille in order to extend it all the way to the floor.1. To see if the skirt is needed, place the base grille into position.Do not attach the base grille to the refrigerator. Measure thedistance between the bottom of the base grille and the floor.The gap must be a minimum of ¹⁄₂" (1.27 cm) in order to addthe skirt.NOTE: If the gap measures less than ¹⁄₂" (1.27 cm), skipsteps 3 and 4 of the instructions, and install the base grilleonly.2. Remove the film from the base grille.3. Snap the skirt onto the base grille.4. Trim the skirt by scoring the proper “V” groove with a utilityknife. Break the skirt at the score line.5. Using the two screws, attach the base grille assembly to therefrigerator as shown.NOTE: Drive in the right side screw first.Complete Installation1. Turn the water supply line valve to the “Open” position.2. Turn the refrigerator switch to the ON position. See “PowerOn/Off Switch” in the Use & Care Guide for instructions. Waita few minutes. Check the water line connections for leaks.3. Remove all boxes, parts packages and packing materials fromthe interior of the refrigerator. See the “Cleaning” section inthe Use & Care Guide for instructions. Remove the film andcardboard from the grille and doors or door frame, dependingon your model.4. Install the shelves and bins in the refrigerator and freezercompartments.5. The controls are preset at the factory to the midpoint setting.Check that the compressor is operating properly and that allthe lights are working.6. If construction will continue after the refrigerator has beeninstalled, set the controls to OFF.To get the most efficient use from your new built-in refrigerator,read the Use & Care Guide. Keep Installation Instructions and Use& Care Guide near the built-in refrigerator for easy reference.Water System PreparationPlease read before using the water system.Immediately after installation, follow the steps below to make surethat the water system is properly cleaned.1. Turn off the ice maker. Slide the ice maker On/Off control,located on the left-hand side of the ice bin, to the OFF (down)position as shown.NOTE: If your model has a base grille filter system, make sure thebase grille filter is properly installed.2. Turn on the ice maker. Slide the ice maker On/Off control,located on the left-hand side of the ice bin, to the ON (up)position. Please refer to “Ice Maker and Storage Bin” forfurther instructions on the operation of your ice maker.■ Allow 24 hours to produce the first batch of ice.■ Discard the first three batches of ice produced.A. Base grilleB. SkirtA. “V” grooveA. Screws (2)ABAAA. On/Off controlADo not use with water that is microbiologically unsafe or ofunknown quality without adequate disinfection before orafter the system.