Jenn-Air JDB1080AW Use & Care Manual

Also see for JDB-5: Use & care guide Use & care guide Use & care guide Use & care guide

Contents

Jenn-Air JDB1080AW Use & Care Manual Manual pdf 9 page image

LOADINGAdjustabme Racks (select models:}The AdjustaNe Upper Rack (select models} andAdjustabme Middle Rack can be raised or lowered toaccommodate taller plates, platters, pans, etc. in theupper, middle or lower racks. Full size dinner platescan be loaded in the upper rack if it is in the lowerposition. Always unload racks before adjusting.To lower the rack:1. Pull the rack fully ouL2. Place thumbson each leveron the adjusterwhile holdingrack withhands.Adjusters3. Press down onthe levers withthumbs and push rack down. The rack will cometo a stop when it is in position.To raise the rack:1. Pull the rack fully out.2. Place hands on both sides and lift up until rackcomes to a stop and latches in place.. The dishwasher well notoperate correctly if therack wash armconnection is not amignedwith one of the waterintact holes on back wallof the dishwasher.. The left and right side adjusters on the racksmust both be fully in the upward or downwardposition for proper connection.Removing the Upperand Middle £acksThe racks can be removed when tall or oversized itemsneed to be loaded into the middle or lower rack.Unload the rack before removing it from the dishwashenTo remove rack with push tab rack stops (selectmodels):1. Roll the rack '/._to 't, of the way out...To remove each plastic push tab rack stop fromthe end of each track, push inward (toward therack} on the ridged area of the rack stop. The rackstop will snap open and can be easily removed bypulling straightout. Take care tosupport the trackwhile removingrack stops.Roll the rack allthe way out ofthe track andremove from thedishwasher,To replace:Push TabRack Stop. Reverse the above procedure to replace the rack intothe dishwasher`To remove rack with tabqock rack stops(select models)1. Roll the rack 113 to 112 of the way out.2, Locate the rack stops at the end of each track.Squeeze the tab in the middle of the rack stop andpull the rack stop straight out, Take care to supportthe rack while removing the rack stops.3. Roll the rack all the .............way out of thetrack and removefrom thedishwasher,To rephce:1, Replace the Tab Lockdishwasher rack by Rack Stopguiding the wheels into the tracks,2. Push each rack stop squarely into the end of thetrack until the catch pops into the small hole on theside of the track.