©v C hSSThe ovens use either a 120-volt, 20-watt maximum halogen bulband/or a standard 40-watt appliance bulb.To Replace Standard Oven Light:Before replacing, make sure the oven is off and cool.1. Unplug range or disconnect power.2. Turn the glass bulb cover in the back of the ovencounterclockwise to remove.3. Turn bulb counterclockwise to remove from socket.4. Replace bulb and bulb cover by turning clockwise.5. Plug in range or reconnect power.To Replace Halogen Light:Before replacing, make sure the oven is off and cool.1. Unplug range or disconnect power.2. Use fingertips to grasp edge of bulb cover. Pull out andremove.3. Remove bulb from socket by pulling straight out of theceramic base.4. Replace bulb, using tissue or wearing cotton gloves to handlebulb. To avoid damage or decreasing the life of the new bulb,do not touch bulb with bare fingers.5. Replace bulb cover by snapping back into place.6. Plug in range or reconnect power.For normal range use, it is not suggested to remove the ovendoor. However, if removal is necessary, make sure the oven is offand cool. Then, follow these instructions. The oven door is heavy.To Remove:1. Open oven door to the first stop position (opened about4" (10.0 cm).2. Grasp door at each side. Do not use the door handle to liftdoor.3. Lift up evenly until door clears hinge arms.To Replace:1. Grasp door at each side.2. Align slots in the door with the hinge arms on the range.3. Slide the door down onto the hinge arms until the door iscompletely seated on the hinges. Push down on the topcorners of the door to completely seat door on hinges. Doorshould not appear crooked.TROUBLESHOOTINGTry the solutions suggested here first in order to avoid the cost of an unnecessary service call.Nothing will operate• Household fuse blown or circuit breaker tripped? •Replace the fuse or reset the circuit breaker. If the problemcontinues, call an electrician.• Is the range properly connected to the gas supply?Contact a trained repair specialist or see InstallationInstructions. •Surface burners will not operate• Is this the first time the surface burners have been used?Turn on any one of the surface burner knobs to release airfrom the gas lines.• Is the control knob set correctly?Push in knob before turning to a setting.• Are the burner ports clogged?See "Sealed Surface Burners" section.• Is the main or regulator gas shutoff valve in the offposition?See Installation Instructions.Surface burner flames are uneven, yellow and/or noisyAre the burner ports clogged?See "Sealed Surface Burners" section.Are the burner caps positioned properly?See "Sealed Surface Burners" section.Is propane gas being used?The range may have been converted improperly. Contact aservice technician or see "Assistance or Service" section.Surface burner makes popping noises• Is the burner wet?Let it dry.Excessive heat around cookware on cooktopIs the cookware the proper size? Use cookware about thesame size as the surface cooking area, element or surfaceburner. Cookware should not extend more than 1" (2.5 cm)outside the cooking area.20