Jenn-Air JF36NXFXDE Installation Manual

Also see for JF36NXFXDE: Design and planning guide

Contents

Jenn-Air JF36NXFXDE Installation Manual Manual pdf 20 page image

206. Fasten the shutoff valve to the cold water pipe with the pipeclamp. Be sure the outlet end is solidly in the 1/4" (6.35 mm)drilled hole in the water pipe and that the washer is under thepipe clamp. Tighten the packing nut. Tighten the pipe clampscrews slowly and evenly so washer makes a watertight seal.Do not overtighten.IMPORTANT: Before attaching the tubing to shutoff valve, flushthe main water supply line to remove particles and air in the waterline. Allow enough flow so that water becomes clear. Flushingthe water line may help avoid filters and/or water valves frombecoming clogged.7. Slip the compression sleeve and compression nut on thecopper tubing as shown. Insert the end of the tubing into theoutlet end squarely as far as it will go. Screw compression nutonto outlet end with adjustable wrench. Do not overtighten theclamp or the sleeve. This will crush the copper tubing.8. Turn off the shutoff valve on the water pipe. Coil the coppertubing.9. Connect the flexible, codes-approved water supply line to thewater shutoff valve by threading the provided nut onto theshutoff valve.10. Place the end of the tubing into a bucket, and turn shutoffvalve ON.11. Check for leaks around the saddle valve. Tighten any nuts orconnections (including connections at the valve) that leak.Connect to RefrigeratorParts Supplied■ 1/4" to 1/4" (6.35 mm to 6.35 mm) male-to-male couplingNOTE: The flexible, codes-approved water supply line shouldconnect to the supply valve through the floor.1. Unplug the refrigerator or disconnect power.2. Connect the 7 ft (2.13 m) flexible codes-approved water tubeto the water supply valve.3. Flush the main water supply line to remove particles and air inthe water line. Allow enough flow so that water becomes clear.4. Tape the 7 ft (2.13 m) flexible codes-approved water supplyline to the floor, 7" (17.78 cm) from the left side of therefrigerator. Tape along the length of the tubing, which willallow it to pass beneath the refrigerator without interference.NOTE: Allow a minimum of 26" (66.04 cm) of flexible codes-approved water supply line to be loose at the front of therefrigerator for connecting to the refrigerator.5. Connect the 7 ft (2.13 m) flexible codes-approved water supplyline to the refrigerator.NOTE: If the main water shutoff valve is behind the refrigerator,a secondary water shutoff valve may be installed in line withthe water supply line at the front of the product.6. Turn on the water supply valve and check all connections forleaks.Plug in RefrigeratorIf the supply cord is damaged, it must be replaced by themanufacturer or its service agent or a similar qualified person. Donot use a cord that shows cracks or abrasion damage along itslength or at either the plug or connection end.1. Set control switch at top of cabinet to the OFF position.2. Plug into a grounded 3 prong outlet.ABCDEF GA. Household water lineB. Nut (purchased)C. Ferrule (purchased)D. CouplingE. BulbF. NutG. Refrigerator water tubingElectrical Shock HazardPlug into a grounded 3 prong outlet.Do not remove ground prong.Do not use an adapter.Do not use an extension cord.Failure to follow these instructions can result in death,fire, or electrical shock.WARNING6"(15.2 cm) 6"(15.2 cm)1"(2.54 cm)7"(17.78 cm)