Jenn-Air JGCP430ADP Installation Instructions Manual

Also see for PRO-STYLE JGCP430ADP: Use & care guide Use and care guide Use & care guide

Contents

Jenn-Air JGCP430ADP Installation Instructions Manual Manual pdf 9 page image

9To Convert Appliance For Use With Natural GasElectrical power and gas must be turnedoff prior to conversion.WARNINGIf this appliance has been converted for use with LP gas,each of the following modifications must be performed toconvert the unit back to natural gas.A. Replace all orifice spudsPerform Steps 1 through 3 on page 6.For Step 4: Locate the colored brass natural gasorifice spuds that were originally installed in thisappliance before its conversion for use with LP gas.Observe the color of each of the spuds and note thecorrect burner location for each spud as shown onpage 10 figures 17, 18 or 19.Complete Steps 5, 6, and 7 on page 6 to completethe installation of natural gas main spuds in theircorrect locations.Save the orifices removed from the appliance forfuture use. They will be needed if this appliance isagain converted for use with LP gas.B. Invert cap in appliance pressureregulator.(See figure 13 or 14.)With the appliance installed the appliance regulatorshould be located as shown in figure 8. Identify thetype of appliance regulator and follow the instructionsin the appropriate illustration.C. Adjust low flame as instructed on page 8item C.After Steps A, B and C have been completed, checkthe appearance of each burner’s flame at the Hi andLo settings against figure 16. If the flames appear toolarge or too small, make sure all steps werecompleted correctly.