Jenn-Air JS42NXFXDW00 Installation Manual

Also see for JS42NXFXDW: Design and planning guide Installation instructions Installation guide Installation guide Installation instructions

Contents

Jenn-Air JS42NXFXDW00 Installation Manual Manual pdf 15 page image

153. Continue adjusting all of the leveling legs to raise therefrigerator until the top is within at least ¹⁄₄" (6.35 mm) of thetop soffit.NOTE: If an anti-tip board has been used, adjust the levelinglegs until the top of the refrigerator is within ¹⁄₄" (6.35 mm) ofthe bottom of the anti-tip board as shown. Do not crush thecompressor cover.IMPORTANT: Adjust in small increments to keep fromdamaging the cabinet trim and causing problems with thedoor alignment or top grille fit. To avoid damage to the cabinetor leveling legs, do not apply more than 50 inch-pounds(5.65 Nm) of torque to the leveling bolts. The leveling legs canbe extended to a maximum of 1¹⁄₄" (3.18 cm) below the rollers.4. After leveling the refrigerator, again use a straight edge or4 foot level across the front of the refrigerator installationblocks to the cabinets to check that the refrigerator is stillflush.Install Refrigerator and Overlay PanelsIMPORTANT: Jenn-Air is not responsible for the removal oraddition of molding or overlay panels that would not allow accessto the refrigerator for service.Install Refrigerator to Adjacent Cabinets1. Open the refrigerator and freezer doors to locate the cabinetbrackets on each side.2. Using the bracket holes as a template, predrill a ¹⁄₈" deep pilothole into the adjacent cabinet.3. Using two round head screws (provided) for each bracket,anchor the refrigerator to the adjacent cabinets.4. Repeat steps 2 and 3 to anchor the other side of therefrigerator to the adjacent cabinets.Install Cabinet Side TrimsInstall cabinet side trims to hide the brackets fastening therefrigerator to the adjacent cabinets.1. Open both doors to a 90° angle.2. With the lip edge of the trim toward the back wall, insert thecabinet side trim between the side of the refrigerator and theadjacent cabinetry.NOTE: Keep the top edge of the trim piece flush with the topof the refrigerator. Installing the trim higher than therefrigerator top could cause damage to the trim when the dooris opened.3. Slide the trim toward the back until it snaps into place.A. Center board¹⁄₄" (6.35 mm) max. above refrigeratorB. Two 2" x 4" x 32" (5 cm x 10 cm x 81 cm) boardsC. Attach to studs with six #8 x 3" (7.6 cm) screwsD. Compressor coverE. Distance from bottom of anti-tip board to floorBAC2" (5 cm)D¹⁄₄" (6 mm)max.84"(213.4 cm)EA. Cabinet side trimB. Freezer doorAB