Jenn-Air JS42NXFXDW00 Installation Manual

Also see for JS42NXFXDW: Design and planning guide Installation instructions Installation guide Installation guide Installation instructions

Contents

Jenn-Air JS42NXFXDW00 Installation Manual Manual pdf 20 page image

204. Trim the skirt by scoring the proper “V” groove with a utilityknife. Break the skirt at the score line.5. Using the two screws, attach the base grille assembly to therefrigerator as shown.NOTE: Drive in the right side screw first.Complete Installation1. Turn the water supply line valve to the “Open” position.2. Turn the refrigerator switch to the ON position. See “PowerOn/Off Switch” in the Use & Care Guide for instructions. Waita few minutes. Check the water line connections for leaks.3. Remove all boxes, parts packages and packing materials fromthe interior of the refrigerator. See the “Cleaning” section inthe Use & Care Guide for instructions. Remove the film andcardboard from the grille and doors or door frame, dependingon your model.4. Install the shelves and bins in the refrigerator and freezercompartments.5. The controls are preset at the factory to the midpoint setting.Check that the compressor is operating properly and that allthe lights are working.6. Flush the water system before use. See “Water SystemPreparation.”To get the most efficient use from your new built-in refrigerator,read the Use & Care Guide. Keep Installation Instructions and Use& Care Guide near the built-in refrigerator for easy reference.Water System PreparationPlease read before using the water system.Immediately after installation, follow the steps below to make surethat the water system is properly cleaned.1. Open the freezer door and turn off the ice maker. For Style 1,lift up the wire shutoff arm as shown. For Style 2, move theswitch to the OFF (right) setting as shown. The On/Off switchis located on the top right side of the freezer compartment.Style 1 – Non-Dispenser ModelsStyle 2 – Dispenser ModelsNOTE: If your model has a base grille filter system, make sure thebase grille filter is properly installed and the cap is in the horizontalposition.2. Use a sturdy container to depress and hold the waterdispenser lever for 5 seconds, then release it for 5 seconds.Repeat until water begins to flow. Once water begins to flow,continue depressing and releasing the dispenser lever(5 seconds on, 5 seconds off) for an additional 2 minutes. Thiswill flush air from the filter and water dispensing system.Additional flushing may be required in some households.NOTE: As air is cleared from the system, water may spurt outof the dispenser.3. Open the freezer door and turn on the ice maker. For Style 1,lower the wire shutoff arm. For Style 2, move the switch to theON (left) position.■ Allow 24 hours to produce the first batch of ice.■ Discard the first three batches of ice produced.■ Depending on your model, you may want to select themaximum ice feature to increase the production of ice.A. “V” grooveA. Screws (2)AADo not use with water that is microbiologically unsafe orof unknown quality without adequate disinfection beforeor after the system. Systems certified for cyst reductionmay be used on disinfected waters that may containfilterable cysts.