Jenn-Air JS42NXFXDW01 Use & Care Manual

Contents

Jenn-Air JS42NXFXDW01 Use & Care Manual Manual pdf 19 page image

PERFORMANCE DATA SHEETSBase Grille Water Filtration SystemModel T2WG2L/T2RFWG2 Capacity 200 Gallons (757 Liters)Model T2WG2/T2RFWG2 Capacity 200 Gallons (757 Liters)@ System tested and certified by NSF International against NSF/ANSIStandard 42 for the reduction of Chlorine Taste and Odor, ParticulateClass I1"; and against NSF/ANSI Standard 53 for the reduction of Mercury,Benzene, Toxaphene, O-dichlorobenzene, and Carbofuran.This system has been tested according to NSF/ANSI Standards 42 and 53 for the reduction of the substances listed below. Theconcentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to thepermissible limit for water leaving the system, as specified in NSF/ANSI Standards 42 and 53.Substance Reduction NSF Reduction Average Influent Challenge Maximum Average Minimum % Average %Aesthetic Effects Requirements Influent Concentration Effluent Effluent Reduction ReductionChlorine Taste/Odor 50% reduction 2.0182 mg/L 2.0 mg/L + 10% 0.06 mg/L ** 0.0536 mg/L 97.03 97.34Particulate Class I1" 85% reduction 1333333 #/mL At east 10,000 part c es/mL 6600 #/mL 2325 #/mL 99.51 99.83Contaminant NSF Reduction Average Influent Challenge Maximum Average Minimum % Average %Reduction Requirements Influent Concentration Effluent Effluent Reduction ReductionLead: @ pH 6.5*** 0.010 mg/L 0.1533 mg/L 0.15 mg/L + 10% 0.0005 mg/L 0.0005 mg/L 99.67 99.67Lead: @ pH 8.5*** 0.010 mg/L 0.1400 mg/L 0.15 mg/L _+10% 0.0007 mg/L 0.0006 mg/L 99.50 99.57Mercury: @ pH 6.5 0.002 mg/L 0.0058 mg/L 0.006 mg/L + 10% 0.0002 mg/L 0.0002 mg/L 96.54 96.54Mercury: @ pH 8.5 0.002 mg/L 0.0059 mg/L 0.006 mg/L _+10% 0.0005 mg/L 0.0003 mg/L 91.57 94.92Benzene 0.005 mg/L 0.0154 mg/L 0.015 mg/L _+10% 0.0012 mg/L 0.0006 mg/L 92.22 96.34O-Dichlorobenzene 0.6 mg/L 1.7571 mg/L 1.8 mg/L _+10% 0.0250 mg/L 0.0066 mg/L 98.58 99.63Toxaphene 0.003 mg/L 0.015 mg/L 0.015 mg/L _+10% 0.001 mg/L 0.001 mg/L 93.33 93.33Carbofuran 0.04 mg/L 0.0819 mg/L 0.08 mg/L _+10% 0.0400 mg/L 0.0213 mg/L 51.13 74.00Test Parameters: pH = 7.5 _+0.5 unless otherwise noted. Flow = 0.85 gpm (3.2 Lpm). Pressure = 60 psig (413.7 kPa).Temp. = 68°F to 71.6°F (20°C to 22°C). Rated service capacity = 200 gallons (757 liters).• It is essential that operational, maintenance, and filter •replacement requirements be carried out for the product toperform as advertised.• Use replacement filter T2RFWG2, part #4396841.2010 suggested retail price of $39.99 U.S.A./S54.95 Canada.Prices are subject to change without notice.Model T2WG2L: Style 1 - When the filter indicator reads 10%,order a new filter. When the indicator reads 0%, it isrecommended that you replace the filter.Style 2 - When the filter indicator changes from green to yellow,order a new filter. When the indicator changes from yellow to red,it is recommended that you replace the filter.Style 3 - When the water filter status display changes from"GOOD" to "ORDER," order a new filter. When the filter indicatorreads "REPLACE," it is recommended that you replace the filter.Style 4 - Press FILTER to check the status of your water filter. Ifthe filter indicator light is yellow, order a new filter. If the filterindicator light is red, it is recommended that you replace the filter.Model T2WG2: Change the water filter cartridge every 6 months.If the water flow to the water dispenser or ice maker decreasesnoticeably before 6 months have passed, replace the water filtercartridge more often.These contaminants are not necessarily in your water supply.While testing was performed under standard laboratoryconditions, actual performance may vary.• The product is for cold water use only.• Do not use with water that is microbiologically unsafe or ofunknown quality without adequate disinfection before or after thesystem.• Refer to the "Warranty" section for the Manufacturer's name,address and telephone number.• Refer to the "Warranty" section for the Manufacturer's limitedwarranty.Application Guidelines/Water Supply ParametersWater Supply City or WellWater Pressure 30 - 120 psi (207 - 827 kPa)Water Temperature 33 ° - 100°F (0.6 ° - 37.8°C)Service Flow Rate 0.85 gpm (3.2 Lpm) @ 60 psi*Class II particle size: 1 um to <5 um**Test requirement is at least 100,000 particles/mL of AC Fine Test Dust.***Compliant for Lead reduction requirements under NSF/ANSl Standard 53 as tested by Pace Analytical Services, Inc.® NSF is a registered trademark of NSF International.19