Jenn-Air JS42PPDUDB00 Installation Manual

Also see for Pro-Style JS42PPDUDB: Design and planning guide Installation guide Installation guide Installation guide Installation guide

Contents

172. Push the top grille straight up; then pull straight out. Lay thegrille on a soft surface.3. Remove the six screws attaching each cabinet side trim to therefrigerator and remove the side trims.Move the Refrigerator into House1. Place an appliance dolly under the left side of the refrigeratoras shown. Be sure to protect the side trims and handles. Placethe corner posts from the packing materials over the trims andhandles as appropriate. Slowly tighten the strap.NOTE: Pass the dolly strap under the handles for theArchitect ® Series.2. Place pieces of the shipping carton on the floor when rollingthe dolly and refrigerator into the house. Move the refrigeratorclose to the built-in opening.3. Place top of cardboard carton or plywood under refrigerator.4. Stand the refrigerator up. First, place the left bottom edge ofthe refrigerator on the floor, stand the refrigerator upright andthen lower the right-hand side of the refrigerator to the floor.5. Do not remove protective film or cover.6. Reassemble the trim and top grille after the dolly has beenremoved from the refrigerator.Install Anti-Tip BoardsIMPORTANT:■ To avoid tipping during use, the solid soffit must be within 1"(2.5 cm) maximum above the refrigerator. If the solid soffit ishigher than 1" (2.5 cm) or one is not available, then therefrigerator must be braced.■ It is recommended that board(s) be installed before therefrigerator is installed.■ Board(s) must be long enough to fully cover the width of thecompressor cover.■ Locate the board(s) so the bottom surface(s) of the board(s)is(are) 84" (213 cm) from the floor.■ During installation, raise the refrigerator up so there is ¹⁄₄"(6.35 mm) maximum between the top of the refrigerator andthe bottom of the anti-tip board(s). Do not crush thecompressor cover when raising the rear leveling legs.To Install Anti-tip Boards1. Mark the stud locations on rear wall 80" to 90" (203 cm to229 cm) above floor.2. Securely attach one or two 2" x 4" x 32" (5 cm x 10 cm x81 cm) boards to wall studs behind refrigerator. Use six#8 x 3" (7.6 cm) (or longer) wood screws. The wood screwsmust be screwed into the studs at least 1½" (3.8 cm). Theboard(s) must overlap the compressor cover.A. Top grilleB. Cabinet side trimBBAWARNINGTip Over HazardRefrigerator is top heavy and tips easily when notcompletely installed.Keep doors taped closed until refrigerator iscompletely installed.Use two or more people to move and installrefrigerator.Failure to do so can result in death or serious injury.A. Center board¹⁄₄" (6.35 mm) max. above refrigeratorB. Two 2" x 4" x 32" (5 cm x 10 cm x 81 cm) boardsC. Attach to studs with six #8 x 3" (7.6 cm) screwsD. Compressor coverBAC2" (5 cm)D