Jenn-Air JS42PPDUDB00 Installation Manual

Also see for Pro-Style JS42PPDUDB: Design and planning guide Installation guide Installation guide Installation guide Installation guide

Contents

203. Continue adjusting all of the leveling legs to raise therefrigerator until the top is within at least 1" (2.54 cm) of thetop soffit.NOTE: If an anti-tip board has been used, adjust the levelinglegs until the top of the refrigerator is within ¹⁄₄" (6.35 mm) ofthe bottom of the anti-tip board as shown. Do not crush thecompressor cover.IMPORTANT: Adjust in small increments to keep fromdamaging the cabinet trim and causing problems with thedoor alignment or top grille fit. To avoid damage to the cabinetor leveling legs, do not apply more than 50 inch-pounds(5.65 Nm) of torque to the leveling bolts. The leveling legs canbe extended to a maximum of 1¹⁄₄" (3.18 cm) below the rollers.4. For Classic and Overlay models, additional adjustments maybe needed after the custom panels are installed.Install Overlay Series Custom PanelsIMPORTANT:■ Install the custom handles prior to installing the panels on therefrigerator. For more information on Jenn-Air custom handleselection, refer to the Jenn-Air Catalog, visitwww.jennair.com, or call 1-800-JENNAIR(1-800-536-6247). In Canada, visit www.jennair.ca, or call1-800-807-6777.■ Create custom door overlay panels according to thespecifications in the “Overlay Series Custom Panels” section.■ Jenn-Air not responsible for the removal or addition ofmolding or decorative panels that would not allow access tothe refrigerator for service.Door Panel Installation1. Remove all tape and door bracing from the refrigerator andfreezer doors.2. Open the refrigerator and freezer compartment doors.3. Remove the handle side and top trims.4. Slide the custom panels into the bottom and hinge side trimson the refrigerator compartment and freezer compartmentdoors, making sure that the backer panel fits into the hingeside trims.5. Reinstall the handle-side and top trims.6. Remove the protective skin from the screw covers. Slide orsnap the screw covers into the handle trim section.7. Check refrigerator level and alignment. Adjust if needed.A. Center board¹⁄₄" (6.35 mm) max. above refrigeratorB. Two 2" x 4" x 32" (5 cm x 10 cm x 81 cm) boardsC. Attach to studs with six #8 x 3" (7.6 cm) screwsD. Compressor coverBAC2" (5 cm)D¹⁄₄" (6 mm)max.A. TrimsA. PanelsAAAA