Jenn-Air JUD24FR*S Series Use & Care Manual

Contents

17PRODUCT DATA SHEETSBase Grille Water Filtration SystemModel WF-L200V Capacity 200 Gallons (757 Liters)Model WF-NL120V Capacity 120 Gallons (454 Liters))This system has been tested according to ANSI/NSF 42/53 for the reduction of the substances listed below. The concentration ofthe indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit forwater leaving the system, as specified in ANSI/NSF 42/53.Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.5 gpm (1.9 Lpm). Pressure = 60 psig (413.7 kPa). Temp. = 63°F(17.2°C).■ It is essential that operational, maintenance, and filterreplacement requirements be carried out for the product toperform as advertised.■ Model WF-L200V: The filter monitor system measures theamount of water that passes through the filter and alerts youto replace the filter. When 90% of the filter’s rated life is used,the filter indicator light changes from green to yellow. When100% of the filter’s rated life is used, the filter indicator lightchanges from yellow to red, and it is recommended that youreplace the filter. Use replacement cartridge L200V / NL120V,part #4396702. 2013 suggested retail price of $32.99 U.S.A./$49.99 Canada. Prices are subject to change without notice.Model WF-NL120V: Change the water filter cartridge every 6-9 months. Use replacement cartridge L200V / NL120V, part#4396702. 2013 suggested retail price of $32.99 U.S.A./$49.99 Canada. Prices are subject to change without notice.■ The product is for cold water use only.■ Do not use with water that is microbiologically unsafe or ofunknown quality without adequate disinfection before or afterthe system.■ Refer to the front cover or “Accessories” section for theManufacturer’s name, address and telephone number.■ Refer to the “Warranty” section for the Manufacturer’s limitedwarranty.Application Guidelines/Water Supply ParametersSubstance ReductionAesthetic EffectsNSF ReductionRequirementsAverageInfluentInfluent ChallengeConcentrationMaximumEffluentAverageEffluentMinimum %ReductionAverage %ReductionChlorine Taste/OdorParticulate Class III* ≥50%≥85%1.9 mg/L49,333/mL2.0 mg/L ± 10%At least 10,000 particles/mL0.07 mg/L640 mg/L**0.06 mg/L312 mg/L>75.0%98.7%>75.0%99%ContaminantReductionNSF ReductionRequirementsAverageInfluentInfluent ChallengeConcentrationMaximumEffluentAverageEffluentMinimum %ReductionAverage %ReductionLead: @ pH 6.5Lead: @ pH 8.50.01mg/L0.01mg/L0.14 mg/L***0.15 mg/L***0.15 mg/L ± 10%0.15 mg/L ± 10%0.0014 mg/L0.0069 mg/L0.0011 mg/L0.0042 mg/L99.0%95.4%99.21%97.08%Mercury: @ pH 6.5Mercury: @ pH 8.50.002 mg/L0.002 mg/L0.0059 mg/L0.0054 mg/L0.006 mg/L ± 10%0.006 mg/L ± 10%0.0009 mg/L0.0007 mg/L0.0004 mg/L0.00043 mg/L84.74%87.03%92.47%91.93%Benzene 0.0050 mg/L 0.0157 mg/L 0.015 ± 10% 0.002 mg/L 0.00083 mg/L 87.26% 94.71%p-dichlorobenzene 0.075 mg/L 0.210 mg/L 0.225 ± 10% 0.0005 mg/L 0.0005 mg/L 99.76% 99.76%Tested and certified by NSF International against ANSI/NSF Standard42 for the reduction of Chlorine, Taste and Odor, Particulate Class lll*;and against ANSI/NSF Standard 53 for the reduction of Lead,Mercury, Benzene, and p-dichlorobenzene.Water SupplyWater PressureWater TemperatureService Flow RateCity or Well30 - 120 psi (207 - 827 kPa)33° - 100°F (0.6° - 37.8° C)0.5 GPM (1.89 L/min.) @ 60 psi.******Class III particle size: >5 to <15 umTest requirement is at least 10,000 particles/mL of AC Fine Test Dust.These contaminants are not necessarily in your water supply. Performance may vary based on local water conditions.® NSF is a registered trademark of NSF International.