Jenn-Air JXI8036WS Installation Instructions And Use & Care Manual

Also see for JXI8036WS: Installation Instructions and Use & Care Guide

Contents

Jenn-Air JXI8036WS Installation Instructions And Use & Care Manual Manual pdf 5 page image

INSTALLATIONREQUIREMENTSGather the required tools and parts before starting installation.Read and follow the instructions provided with any tools listedhere.Tools needed• Level• Drill with 11¼'' (3.0 cm), 3/8"(9.5 mm), 7/64"(2.75 mm) and1/8"(3.0 mm) drill bits• Pilot hole drill bits (determined by chimney supportattachment method)• Pencil• Wire stripper or utility knife• Tape measure or ruler• Pliers• Caulking gun and weatherproof caulking compound• Vent clamps• Jigsaw or keyhole saw• Flat-blade screwdriver• Metal snips• Phillips screwdriverParts needed• Home power supply cable• 2 - 1/2"(12.7 mm) UL listed or CSA approved strain reliefs• 3 UL listed wire connectorsFor vented installations, you will also need:• 1 wall or roof cap• Metal vent systemFor non-vented (recirculating) installations, you will alsoneed:• Recirculating Kit Part Number W10272061 for non-vented(recirculating) installations only. See "Assistance or Service"section to order.• 8" (20.3 cm) round metal vent duct. Length required isdetermined by ceiling height.Parts suppliedRemove parts from packages. Check that all parts are included.• Hood canopy assembly with ventilator and light bulbsinstalled• Filter- installed in hood canopy• 68-4x8mmscrews• 4-5x45mmscrews• Mounting template• 4 vent covers with 4 trim piecesIMPORTANT: Observe all governing codes and ordinances.Have a qualified technician install the range hood. It is theinstaller's responsibility to comply with installation clearancesspecified on the model/serial rating plate. The model/serial ratingplate is located behind the left filter on the rear wall of the venthood.Canopy hood location should be away from strong draft areas,such as windows, doors and strong heating vents.Cabinet opening dimensions that are shown must be used. Givendimensions provide minimum clearance.Grounded electrical outlet is required. See "ElectricalRequirements" section.Because of the size and weight of this island hood, the chimneysupport must be securely attached to the ceiling.• For plaster or drywall ceilings, the chimney support must beattached to joists. If this is not possible, you must build asupport structure behind the plaster or drywall. The supportstructure must be able to support 80 Ibs (36.6 kg).The range hood is factory set for venting through the roof.For non-vented (recirculating) Installation see "Non-vented(recirculating) Installations" in "Install Range Hood" section.Recirculation Kit Part Number W10272061 is available from yourdealer or an authorized parts distributor.All openings in ceiling and wall where range hood will be installedmust be sealed.For Mobile Home InstallationsThe installation of this range hood must conform to theManufactured Home Construction Safety Standards, Title 24CFR, Part 328 (formerly the Federal Standard for Mobile HomeConstruction and Safety, Title 24, HUD, Part 280) or when suchstandard is not applicable, the standard for Manufactured HomeInstallation 1982 (Manufactured Home Sites, Communities andSetups) ANSI A225.1/NFPA 501A, or latest edition, or with localcodes.Product Dimensions12¼"(31.0 crn)(33.5cm)36" (91.2 27" (68.6 crn)*Vented installations only**Non-vented (recirculating)installations only