Jenn-Air JXI8036WS Installation Instructions And Use & Care Manual

Also see for JXI8036WS: Installation Instructions and Use & Care Guide

Contents

Jenn-Air JXI8036WS Installation Instructions And Use & Care Manual Manual pdf 8 page image

Range Hood Mounting Screws Installation1. Determine and mark the centerline on the ceiling where therange hood will be installed, considering the requirements forceiling support structures. See the "Location Requirements"section. Make sure the range hood is centered over thecooking surface.2. Tape template in place on the ceiling at the markedcenterline.3. Use a pencil to mark the mounting screws, wire access andduct hole locations on the ceiling.NOTE: Mounting hole locations should be into the ceilingsupport structure.Remove the template.4. Drill 4 - 3/le" (4.8 mm) pilot holes for mounting the upperhorizontal support.Complete Preparation1. Determine the required location for the home power supplycable and drill a 1/2"(1.3 cm) diameter hole for wire access.2. Run wire through the home power supply cable according tothe National Electrical Code or CSA Standards and localcodes and ordinances. There must be enough 1/2"conduitand wires from the fused disconnect (or circuit breaker) boxto make the connection in the hood's electrical terminal box.NOTE: Do not reconnect power until installation is complete.3. Use caulk to seal all openings.4. For vented installations only: Using a jigsaw or keyholesaw, cut a 81/2'' (21.6 cm) diameter hole for the vent duct.5. Attach the upper horizontal support bracket with 4 - 5 x45 mm wood screws.AA. Upper horizontal supportInsk:ll t,4o1. Position the vertical supports (A) with notches at the bottomand attach to the range hood using 16 - 4 x 8 mm screws.2. Attach the horizontal support (B) using 8 - 4 x 8 mm screws.3.Ar_B ......... •,4AsfIll IllA. Vertical supportsB. Horizontal supportAttach a second set of vertical supports (A) and set thevertical height (B). See "Installation Dimensions" in the"Location Requirements" section to help determine thedesired dimension for the vertical height "B."B4.A. VerticalsuppoartsB. VerticalheightAttach the range hood assembly to the upper horizontalsupport attached to the ceiling using 16 - 4 x 8 mm screwsand tighten.A ..........l 1l_iiiiii!_i;iiHHHHHHHHHHHHHHHHHHHHHHHHHH@i_,jl_lA. Mounting screws8