Jenn-Air W10379136A Installation Manual

Also see for JS42NXFXDW: Design and planning guide Installation instructions Installation guide Installation guide Installation instructions

Contents

Jenn-Air W10379136A Installation Manual Manual pdf 19 page image

192. Adjust the leveling legs to level and align the refrigerator fromleft to right and front to back so that the refrigerator is leveland aligned with the cabinets.3. Continue adjusting all of the leveling legs to raise therefrigerator until the top is within at least ¹⁄₄" (6.35 mm) of thetop soffit as shown.NOTE: If an anti-tip board has been used, adjust the levelinglegs until the top of the refrigerator is making contact with thebottom of the anti-tip board(s). Do not crush the compressorcover.IMPORTANT: Adjust in small increments to keep fromdamaging the cabinet trim and causing problems with thedoor alignment or top grille fit. To avoid damage to the cabinetor leveling legs, do not apply more than 50 inch-pounds(5.65 Nm) of torque to the leveling bolts. The leveling legs canbe extended to a maximum of 1¹⁄₄" (3.18 cm) below the rollers.4. After leveling the refrigerator, again use a straight edge or4 foot level across the front of the refrigerator installationblocks to the cabinets to check that the refrigerator is stillflush.Install Refrigerator and PanelsIMPORTANT: Jenn-Air is not responsible for the removal oraddition of molding or wood overlay panels that would not allowaccess to the refrigerator for service.Install Top Grille Filler (standard installation only)IMPORTANT: The grille panel height allows the necessary airflowfor refrigerator performance. The top grille filler hides the uppercompartment cover behind the top grille. If you choose to modifythe recommended grille panel dimensions, performance will becompromised.Custom Wood Panel Models1. In the custom made (1" x width of grille panel) wood fillerpiece, drill a hole ¹¹⁄₁₆" from each edge.NOTE: Make sure the hole is centered in the 1" thickness ofthe wood piece.2. Using slotted hex head screws (provided with refrigerator),fasten an “L” bracket to each end of the wood filler piece.3. Using hex head blunt screws (provided with refrigerator),attach the “L” brackets to the top grille mounting plates.4. Adjust the “L” brackets, so that the wood filler piece is flushwith the bottom of the soffit. Completely tighten the screws.Side ViewA. Center board¹⁄₄" (6.35 mm) max. above refrigeratorB. Two 2" x 4" x 32" (5 cm x 10 cm x 81 cm) boardsC. Attach to studs with six #8 x 3" (7.6 cm) screwsD. Compressor coverE. Distance from bottom of anti-tip board to floorBAC2" (5 cm)D¹⁄₄" (6 mm)max.84"(213.4 cm)EA. Custom wood fillerB. “L” bracketC. Grille mounting plateA. Top grille fillerB. SoffitC. AirflowD. Grille panelE. Door panelABCBCDEA