Jenn-Air W10379136A Installation Manual

Also see for JS42NXFXDW: Design and planning guide Installation instructions Installation guide Installation guide Installation instructions

Contents

Jenn-Air W10379136A Installation Manual Manual pdf 23 page image

232. Adjust the panel to achieve the required spacing, or to align.IMPORTANT: If adjustments are needed, adjust the panel notthe door. Adjust left to right in the mounting bracket beforeusing the pins to adjust the panel up and down or at an angle.■ Slide the panel from side to side in the keyhole slot.■ Use an hex key to raise or lower the adjustment pinswhich allows the door panel to swivel.3. Predrill a ¹⁄₈" deep pilot hole the door panel through the openholes in both the bottom and top hinges.4. Using slotted hex head screws (provided with refrigerator),attach the top and bottom hinges to the door panels. Fullytighten all door panel screws.5. Using slotted hex head screws (provided with refrigerator) foreach side, attach the door panels to the hinge-side door trims.6. Using Phillips head flat screws (provided with refrigerator),install the handle side door trim.7. Completely tighten the screws attaching the mountingbrackets, located at the bottom of the doors, to the overlaypanels.8. Reinstall the top door trim and hinge cover.9. Snap the adjustment pin cover (provided with refrigerator) intoplace.Install Handles(Panel Kit Models Only)IMPORTANT: Install the handles after the door panels have beeninstalled. Follow the instructions specific to your door paneldesign.Tools Needed: ³⁄₃₂" hex keyDoor Panels - Custom Wood, Stainless Steel andOiled Bronze Designs1. Locate the holes in the door panels where the handlemounting studs are to be installed.2. Fasten the handle mounting studs to the door panels.3. Install the handles to the handle mounting studs and tightenthe setscrews.Door Panels - Floating Glass DesignIMPORTANT: To align the handle correctly on the door, the plastichandle spacer and the setscrews on the door handle must be inthe positions designated in the chart.1. Locate the holes in the door panels where the handlemounting studs are to be installed.2. Insert the circular post on the back of the handle spacers intothe holes in the door panels.3. Depending on the compartment, rotate the plastic spacer sothat the curved handle mounting posts are either at the top orbottom. See following chart.4. Slide the screw into the handle mounting stud. Insert thescrew assembly into the center hole of the plastic spacer andfasten it to the door panel.5. Install the handles to the handle mounting studs so that thesetscrews are on the designated side and tighten thesetscrews.A. Door panelB. Mounting bracketC. Adjustment pinsA. Top hingeB. Mounting bracketC. Holes for screwsD. Adjustment pinsABCBADC A. Plastic handle spacerB. Straight handle mounting postsC. Curved handle mounting postsD. Circular postFreezerLeft-Hand DoorRefrigeratorRight-Hand DoorCurvedMounting PostBottom TopSetscrews Right LeftA B DCB C