Jensen Twin-Servo 500 series User Manual

Contents

Radial Engineering Ltd. Jensen Twin-Servo 500 ™ ModuleTrue to the Music®3Radial ThumbSet™knurled screws areincluded for easyinstallation.+INPUTOMNIPORTFEEDLINK1234567XER INPUTS 1 ~ 8INPUTFEEDLINKINPUTFEEDLINKINPUTFEEDLINKINPUTFEEDINPUTFEEDINPUTFEEDDIRECT OUT 1 ~ 8 INPUTS 1 ~ 8OFFOFFCARD SLOT 1CARD SLOT 3CARD SLOT 5CARD SLOT 7 CARD SLOT 2CARD SLOT 4CARD SLOT 6OMNIPORTOMNIPORTOMNIPORTOMNIPORTOMNIPORTOMNIPORTMade in CanadaRadial Engineering Ltd.OFFOFFOFFOFFOFFOFFOFFOFFOFFOUTPUT OUTPUT OUTPUT OUTPUT OUTPUT OUTPUT OUTPUTOUTPUT INPUT OUTPUT INPUT OUTPUT INPUT OUTPUT INPUT OUTPUT INPUT OUTPUT INPUT OUTPUT INPUTPIN DIAGRAM - PANEL VIEW1-+G -+G2 3-+G -+G4 5-G6 7 813ONONMONO2 3 41LEVELCLIPPANMade in CanadaLEVELON6 7 85LEVELMAINMON48V PHANTOM+16V / -16VLEVELCLIPPANONLEVELCLIPPANONLEVELCLIPPANPAN PANPANPANONLEVELCLIPLEVELONLEVELCLIPONLEVELCLIPONLEVELCLIPONOutputREAR PAnELInPUT(WORkHORSE)MakiNG CoNNeCTioNSBefore making connections, ensure your audiosystem is turned off and volume levels turneddown. Hot swapping or inserting the module intoa 500 series power rack when power is on is notrecommended as it can harm some equipment andshorten the lifespan of the card edge connectors.Gently slide the Twin-Servo module into placeensuring you align the card edge with the 15-pinreceptacle. If you have a newer Radial Workhorse,the nylon guides make this easy. The Twin-Servocomes with a pair of handy ThumbSet™ thumbscrews. These should be hand-tightened to securethe module in place before use.Your power rack will likely be equipped with XLR inputs and outputs for each strip. Connectyour microphone to either the female XLR input on the rear panel or the handy front panelCombo connector. These are wired in parallel and only one should be used at any one time.Connect the output using the male XLR on the power rack to your recording system. Ensurethe volume levels on your recording system are turned off and set the volume control on theTwin-Servo fully counter-clockwise to 7:00 o’clock. You are now ready to turn on your powerrack and recording system. note that there is no power switch on the Twin-Servo. As soon asyour power rack is turned on, the Twin-Servo will spring to life.If you are using a condenser microphone, activate the phantom power by depressing thefront panel 48V switch. All other switches should be in the out position. Slowly increase thevolume on your recording system and then turn up the volume on the Twin-Servo. It is alwaysbest to test at low volumes as this will reduce the opportunity of damaging more sensitivecomponents such as tweeters should a connection be improperly seated. You should nowhear the audio and see activity on the 10 bar LED meter.