Jensen VM9022 Installation And Operation Manual

Also see for VM9022 - DVD Player With LCD Monitor: Installation and operation manual Quick start guide Installation and operation manual

Contents

Jensen VM9022 Installation And Operation Manual Manual pdf 9 page image

5VM9022INSTALLATIONISO DIN InstallationThis unit is designed to fit into a 2.0 DIN dashboard opening,found in many imported cars. The unit has threaded holes inthe chassis side panels which may be used with the originalfactory mounting brackets of some Toyota, Nissan,Mitsubishi, Isuzu, Hyundai and Honda vehicles to mount theradio to the dashboard. Please consult with your local carstereo specialty shop for assistance on this type ofinstallation.1. Remove the existing factory radio from the dashboard orcenter console mounting. Save all hardware and brack-ets as they will be used to mount the new radio.2. Remove the factory mounting brackets and hardwarefrom the existing radio and attach them to the new radio.CAUTION: Do not exceed M5 X 6MM screw size. Longerscrews may touch and damage components inside thechassis.3. Place the radio in front of the dashboard opening so thewiring can be brought through the mounting sleeve.Follow the wiring diagram carefully and make certain allconnections are secure and insulated with wire nuts orelectrical tape. After completing the wiring connections,plug the ISO connectors into the mating sockets on therear of the chassis. Turn the unit on to confirm operation(vehicle ignition switch must be “on”). If the unit does notoperate, re-check all wiring until the problem iscorrected.4. Mount the new radio assembly to the dashboard orcenter console using the reverse procedure in step 1.CAUTION: For proper operation of the CD player, thechassis must be mounted within 30° of horizontal. Makesure the unit is mounted within this limitation.NOTE: It is the end-users responsibility to install andoperate this unit in a manner in accordance with local,state and federal laws. The PARKING BRAKE wire MUSTBE CONNECTED as directed in the manual.CAUTION: Do not block the cooling fan exit. If blocked,the unit may overheat and become damaged.Installation Using Half-Sleeve1. Press the metal levers on both sides to remove the half-sleeve from the radio.2. Install the half-sleeve.a. Install adapter if necessary (optional).b. Install half-sleeve into adapter or dashboard (use onlythe supplied screws). Do not force the sleeve into theopening or cause it to bend or bow.c. Locate the series of bend-tabs along the top, bottomand sides of the mounting sleeve. With the sleeve fullyinserted into the dashboard opening, bend as many ofthe tabs outward as necessary so that the sleeve isfirmly secured to the dashboard.3. Use the M5 x 6 screws (provided) to install the mountingbrackets to each side of the radio using the holesindicated below.4. Place the radio in front of the dashboard opening so thewiring can be brought through the mounting sleeve.ISO INSTALLATIONINSTALL HALF SLEEVE2bTABTABDASHBOARDDASHBOARDInstall Bracket HereM5X6SCREWBRACKETNon-DesignatedScrew Prohibited