Jensen VM9115 Installation Manual

Also see for VM9115: Operating instructions

Contents

2VM9115Disconnecting the BatteryTo prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to installation.NOTE: If the VM9115 is to be installed in a car equipped with an on-board drive or navigation computer, do notdisconnect the battery cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, useextra caution during installation to avoid causing a short circuit.Pre-installation1. Remove the four screws that attach the mounting sleeve to theradio and remove the sleeve.2. Install the mounting sleeve:a. Install mounting sleeve into the dashboard or optional adapter.Do not force the sleeve into the opening or cause it to bendor bow.b. Locate the series of bend-tabs along the top, bottom and sidesof the mounting sleeve. With the sleeve fully inserted into thedashboard opening, bend as many of the tabs outward asnecessary so that the sleeve is firmly secured to the dashboard.c. Install the support strap to make the unit more stable.3. Place the radio in front of the dashboard opening so the wiring canbe brought through the mounting sleeve.CAUTION! Be careful not to damage the car wiring.TABDASHBOARDDASHBOARDTABEJ ECTA / VINPU T2b2c2a

/ 4

Related manuals for Jensen VM9115