Jensen VM9115 Installation Manual

Also see for VM9115: Operating instructions

Contents

3VM9115WiringWARNING! Only connect the unit to a 12-volt power supply with proper grounding.Complete wiring as illustrated in the wiring diagram on page 4. Once the wiring is complete, reconnect the batterynegative terminal. If there is no ACC available, connect the ACC lead to the power supply with a switch.NOTE: When replacing a fuse, be sure to use correct type and amperage to avoid damaging the radio. The VM9115 usesone 15 amp fuse, located in the black filter box in-line with the main wire harness.Final InstallationAfter completing the wiring connections, turn the unit on to confirmoperation (ignition switch must be on). If unit does not operate,recheck all wiring until the problem is corrected. Once properoperation is achieved, turn off the ignition switch and proceed withfinal mounting of the chassis.1. Connect the wiring adapter to the existing wiring harness.2. Connect the antenna lead.3. Carefully slide the radio into the mounting sleeve, making sure itis right-side-up, and secure with the original four screws.4. Attach one end of the perforated support strap (supplied) to thescrew stud, which is screwed into the threaded insert on the backof the unit, using the hex nut provided. Fasten the other end ofthe perforated strap to a secure part of the dashboard eitherabove or below the radio using the screw and hex nut provided.Bend the strap to position it as necessary.5. Replace any items you removed from the dashboard.ISO-DIN Installation1. Remove the mounting sleeve brackets.2. Remove the trim ring.3. Mount the factory brackets on the new radio using the existingscrews from the old radio.4. Slide the radio chassis into the dash opening and secure.5. Re-install the dash panel.EJECTA / VINPUT12345CAUTION! The rear of the radio must besupported with the strap to prevent damageto the dashboard from the weight of the radioor improper operation due to vibration.EJECTA / VINPUTEJECTA / VINPUTRemove MountingSleeve Brackets12345NOTE: For proper operation of the CD/DVDplayer, the chassis must be mounted within 20°of horizontal. Make sure the unit is mountedwithin this limitation.

/ 4

Related manuals for Jensen VM9115