Jet 916B Instruction Manual

4D.WORKING ENVIRONMENT:(1).KEEP WORK AREA CLEANS.Cluttered areas and benches invite accidents.(2).DON ‘T USE IN DANGEROUS ENVIRONMENT. Don’t use tools in damp or wet locations, orexpose them to rain. Keep work area well-lighted.(3).KEEP CHILDREN AND VISITORS AWAY. All children and visitors should be kept a safedistance from work area.(4).DON’T install & use this machine in explosive, dangerous environment.E. MAINTENANCE:(1).DISCONNECT machine from power source when making repairs.(2).CHECK DAMAGED PARTS. Before further use of the tool, a guard or other part that is damagedshould be carefully checked to ensure that it will operate properly and perform its intended functioncheck for alignment of moving parts, binding of moving parts, mounting, and any other conditionsthat may affect its operation. A guard or other part that is damaged should be properly repaired orreplaced.(3).DISCONNECT TOOLS before servicing and when changing accessories such as blades, bits,cutters, ect.(4).MAKE SURE that blade tension and blade tacking are properly adjusted.(5).RE-CHECK blade tension after initial cut with a new blade.(6).TO RPOLONG BLADELIFEALWAYS releases blade tension at the end of each work day.(7).CHECK COOLANT DAILY. Low coolant level can cause foaming and high blade temperatures.Dirty or week coolant can clog pump, cause crooked. Cust, low cutting rate and permanent bladefailure. Dirty coolant can cause the growth of bacteria with ensuing skin irritation.(8).WHEN CUTTING MAGNESIUM NEVER use soluble oils or emulsions (oil water mix) as waterwill greatly intensify any accidental magnesium chip fire. See your industrial coolant supplier forspecific coolant recommendations when cutting magnesium.(9). TO PRNMT corrosion of machined surfaces when a soluble on is used as coolant pay particularattention to wiping dry the surfaces where a soluble on is used as coolant, pay particular attention towiping dry the surfaces where fluid accumulates and does not evaporate quickly, such as betweenthe machine bed and vise.F.SPECTIFIED USAGE:This machine is used only for general metals cutting within the range of cutting capacity.G. NOISE:A weighted sound pressure level: 80 DB.H.SAFETY DEVICE: