Jet BD-920W Operating Instructions And Parts Manual

Also see for BD-920W: Brochure Brochure Operating instructions

Contents

Jet BD-920W Operating Instructions And Parts Manual Manual pdf 8 page image

8UnpackingOpen shipping container and check for shipping damage; report any damage immediately to your distributorand shipping agent. Do not discard any shipping material until the Lathe is assembled and running properly.Compare the contents of your container with the following parts list to make sure all parts are intact. Missingparts, if any, should be reported to your distributor. Read the instruction manual thoroughly for assembly,maintenance and safety instructions.Contents of the Shipping ContainerReferring to Figure 1:1 Lathe (not shown)1 6” Four-Jaw Independent Chuck (A)1 Faceplate (B)2 Lifting Plates (C)1 Cover (D)1 4” Three-Jaw Universal Chuck (pre-mounted)1 Four Way Tool Post (pre-mounted)1 Steady Rest (pre-mounted)1 Follow Rest (pre-mounted)1 Operator's Manual (not shown)1 Warranty Card (not shown)2 Shear Pins* (E)3 Chuck Jaws (F)1 Single Tool Post Assembly* (G)1 MT-2 Center* (H)1 MT-3 Center* (I)1 56T Gear* (J)1 52T Gear* (K)1 48T Gear* (L)1 46T Gear* (M)1 44T Gear* (N)1 40T Gear* (O)1 38T Gear* (P)1 36T Gear* (Q)1 32T Gear* (R)1 Tension Roller Lever (S)1 Handle (T)1 Female Chuck Key* (U)2 Male Chuck Keys (V)1 #1 Cross Point Screwdriver* (W)1 #1 Flat Blade Screwdriver* (X)1 5pc Hex Wrench Set (Y)2 Open End Wrenches – 8/10mm, 12/14mm (Z)* parts marked with an asterisk are included in the tool box, stock no. BD920W-TBRead and understand the entire contents of this manual before attempting set-up oroperation! Failure to comply may cause serious injury.CAUTIONThe three jaw chuck and the face plate have a set screw on their flanges that secures them to thethreaded spindle. Before removing the three jaw chuck or the faceplate, remove the set screwcompletely from the flange. Failure to remove the set screw may cause damage to the threads onthe spindle. When installing either the jaw chuck or the faceplate, tighten the set screw firmly toprevent the chuck or the faceplate from coming off the spindle during operation.Figure 1