Jet GHD-20 Operator's Manual

Also see for GHD-20: Brochure Specifications Operating instructions and parts manual

Contents

Jet GHD-20 Operator's Manual Manual pdf 7 page image

Contents of the Shipping Container11111111331111Gear Head Drill PressLug WrenchTouch Up PaintDrill Chuck Arbor (MT-3 x JT-6)DrawbarDrift KeyCrankHandleDownfeed Handles fGHD-20/20T only)Knobs (2 wI the GHD-20PF/20PFT)3mm Hex Wrench4mm Hex Wrench5mm Hex WrenchMain Shaft CoverBefore Assembly1. Finish removing the contents of the shippingcontainer.2. Compare the contents of the shipping containerwith the list found in this manual. Report anyshortages or damage to your JET distributor.3. Clean all rust protected surfaces with keroseneor a light solvent. Do not use lacquer thinner,paint thinner, or gasoline. These will damageplastic components and painted surfaces.Assembly1. Slide crank (A, Fig. 1) onto the table raisingassembly shaft.2. Tighten the set screw (8, Fig. 1) to hold thecrank in place.3. Install the handle (C, Fig. 1) onto the crank.4. For the GHD-20/20T, install three handle andknobs (A, Fig. 2) into the downfeed hub. Forthe GHD-20PF/20PFT, screw two knobs ontothe handles of the power downfeed assembly.Fig. 1Fig. 25