Jet HBS-56S Operating Instructions And Parts Manual

Also see for HBS-56S: Brochure Brochure

Jet HBS-56S Operating Instructions And Parts Manual Manual pdf 8 page image

8Read and understand the entire contents of this manual before attempting set-upor operation! Failure to comply may cause serious injury.Assembly of StandTools required for assembly:Two 1/2-inch wrench (Note: A ratchet wrenchmay speed assembly time.)1. Assemble left (A) and right (B) side plateswith six 5/16"x3/4" hex cap screws (C 1),twelve 5/16” flat washers (D 1) and six 5/16"hex nuts (E1). Tighten the hex nuts.2. Turn the assembly (from Step 1) on its back(door opening up) and mount the bottomplate (F) with two 5/16"x3/4" hex cap screws(C 2), four 5/16” flat washers (D 2) and two5/16" hex nuts (E2). Tighten the hex nuts.3. Install the two rubber feet (G) on the bottomof the left plate (A).4. Turn the assembly upside down and installthe wheel base (H) with four 5/16"x3/4" hexcap screws (C 2), eight 5/16” flat washers(D 2) and four 5/16" hex nuts (E2).5. Insert the axle (J) through the holes of thewheel base (H).6. Install a wheel (K) and two 5/8”x30 flatwashers (L) on each end of the axle. Insertcotter pins (M) through holes on each end ofthe axle and bend the ends of the cotter pinsto secure the wheel on the axle.7. Install the handle (N) to the left side plate (A)with four 5/16”x1-1/2” hex cap screws (O),four 5/16” flat washers (D4) and four 5/16"hex nuts (E4). Tighten the hex nuts.8. Install the door (P). The upper hinge pin isspring loaded and must be retracted tomount the door to the cabinet.9. Install the door lock knob.Installation of the chip pan (R) is described inMounting Band Saw to Stand on the followingpage.Figure 1