Jet JBM-5 Operating Instructions Manual

Also see for JBM-5: Operating instructions and parts manual Operating instructions and parts manual

Contents

EN - ENGLISHOperating InstructionsDear Customer,Many thanks for the confidence you have shown in us with the purchase of your new JET-machine. This manual has beenprepared for the owner and operators of a JET JBM-5 mortiser to promote safety during installation, operation andmaintenance procedures. Please read and understand the information contained in these operating instructions and theaccompanying documents. To obtain maximum life and efficiency from your machine, and to use the machine safely, readthis manual thoroughly and follow instructions carefully.…Table of Contents1. Declaration of conformity2. Warranty3. SafetyAuthorized useGeneral safety notesRemaining hazards4. Machine specificationsTechnical dataNoise emissionContents of delivery5. Transport and start upTransport and installationAssemblyMains connectionDust collectionStarting operation6. Machine operation7. Setup and adjustmentsInstalling chisel and bit180° Head rotationSharpening chisel and bit8. Maintenance and inspection9. Trouble shooting10. Environmental protection11. Available accessories1. Declaration of conformityOn our own responsibility we hereby declare that thisproduct complies with the regulations* listed on page2.Designed in consideration with the standards**.2. WarrantyThe JPW (Tool) AG guarantees that the supplied product isfree from material defects and manufacturing faults.This warranty does not cover any defects which are caused,either directly or indirectly, by incorrect use, carelessness,accidental damage, repair, inadequate maintenance orcleaning and normal wear and tear.Any warranty details (i.e. warranty period) can be found inthe General Terms and Conditions (GTC) that areintegral part of the contract. These GTC can be viewed atthe website of your dealer or sent to you upon request.JPW (Tool) AG reserves the right to make changes to theproduct and accessories at any time.3. Safety3.1 Authorized useThis mortiser is designed for mortising wood and similarmaterials only. Machining of other materials is not permittedand may be carried out in specific cases only afterconsulting with the manufacturer.The workpiece must allow to safely be loaded and clampedfor machining.The proper use also includes compliance with the operatingand maintenance instructions given in this manual.The machine must be operated only by persons familiarwith its operation and maintenance and who are familiarwith its hazards.The required minimum age must be observed.The machine must only be used in a technically perfectcondition.When working on the machine, all safety mechanisms andcovers must be mounted.In addition to the safety requirements contained in theseoperating instructions and your country’s applicableregulations, you should observe the generally recognizedtechnical rules concerning the operation of woodworkingmachines.Any other use exceeds authorization.In the event of unauthorized use of the machine, themanufacturer renounces all liability and the responsibility istransferred exclusively to the operator.3.2 General safety notesWoodworking machines can be dangerous if not usedproperly. Therefore the appropriate general technical rulesas well as the following notes must be observed.Read and understand the entire instruction manual beforeattempting assembly or operation.Keep this operating instruction close by the machine,protected from dirt and humidity, and pass it over to the newowner if you part with the tool.No changes to the machine may be made.