Jet JBM-5 Operating Instructions Manual

Also see for JBM-5: Operating instructions and parts manual Operating instructions and parts manual

Contents

Mains ..................................................... 1~230V, PE, 50HzMotor output power ............................ 0,37 kW (0,5 HP) S1Reference current ......................................................... 3 AExtension cord (H07RN-F):................................. 3x1.5mm²Installation fuse protection ............................................ 10AProtection class ................................................................. I4.2 Noise emissionAcoustic pressure level (EN ISO 11202):Idling ......................................................... LpA 67,4 dB (A)In operation ............................................... LpA 75,5 dB (A)The specified values are emission levels and are notnecessarily to be seen as safe operating levels.As workplace conditions vary, this information is intended toallow the user to make a better estimation of the hazardsand risks involved only.4.3 Content of delivery10mm drill chuckChuck keySpindle extension5/8” (15,87mm) chisel bushing3/4” (19.05mm) chisel bushing13/16” (20,64mm) chisel bushingFence assemblyWork hold downMDF tableHandleGas springOperating manualSpare parts list.5. Transport and start up5.1 Transport and installationThe machine is designed to operate in closed rooms andmust be bolted stable on a firm and levelled table surface.5.2 AssemblyIf you notice transport damage while unpacking, notify yoursupplier immediately. Do not operate the machine!Dispose of the packing in an environmentally friendlymanner.Clean all rust protected surfaces with a mild solvent.Screw the handle (A, Fig 1) into the pinion shaft (B, Fig 1)and tighten (C, Fig 1).Fig 1Use the handle to raise the machine head to the up position.The handle is spring loaded and can be repositioned bypulling the handle away from the head, and turned to thedesired angle.Press the gas spring onto the two fittings (D and E).Attach the MDF table to the base using two screws (A, Fig2).Fig 2Insert bar of fence assembly (B) through the hole in thecolumn. Use the indexable knob (C) to adjust the fenceassembly.Attach the hold down (D) to the vertical post using lockinghandle (E).