the mill/drill is level after the fastening hardwarehas been tightened.LubricationLubricate all ball oilers on the machine once dailywith 20W machine oil.The spindle bearings are permanently sealed andrequire no lubrication.Electrical ConnectionsCURRENT CARRYING PRONGS~ I A/GROUND D.RONGBefore making any electrical connections, make surethe power source available is compatible with themachine. Also, press the Off switch on the front ofthe machine before connecting to the power source.weCZ)The JMO-15 is rated at 115/230V and comes fromthe factory prewired at 115V. This mill/drill comeswith a plug designed for use on a circuit with anoutlet that looks like (A) in Fig. 5. The JMO-15 has agrounding prong as illustrated in (B). A temporaryadapter (C) may be used to connect the plug to atwo pole receptacle (0) if a properly grounded outletis not available. The temporary adapter should onlybe used until a qualified electrician can install aproperly grounded outlet. The green colored plugmust be securely fastened to the cover plate screw.~ROUNDING~~~,~,,~Fig. 5To switch the JMO-15 to 230V operation:1. Disconnect the machine from the powersource.2. Remove the junction box cover on the motor.3. Change the wires according to the diagram onthe inside of the junction box cover.4. Replace the junction box cover.5. Change the plug to one that is rated 230V orhard wire the power cord.6. Change the overload from 18A to10A Specification.6