Jet JVM-836 Operating Instructions And Parts Manual

Also see for JVM-836: Operator's manual Operator's manual

Jet JVM-836 Operating Instructions And Parts Manual Manual pdf 8 page image

87.0 Setup and Assembly7.1 UnpackingOpen shipping container and check for shippingdamage. Report any damage immediately to yourdistributor and shipping agent. Do not discard anyshipping material until the Turret Mill is assembled andrunning properly.Compare the contents of your container with thefollowing parts list to make sure all parts are intact.Missing parts, if any, should be reported to yourdistributor. Read the instruction manual thoroughly forassembly, maintenance and safety instructions.NOTE: Some parts shown below may have come pre-installed on the mill.7.2 Contents of shipping containerRefer to Figure 2.1 Turret Mill (not shown)1 Flat Way Cover (rear)1 Pleated Way Cover (front)1 Knee Crank1 Draw Bar4 Handles1 Tool Box, containing:1 Hex Key Set (1.5-10mm)1 17/19mm Box Wrench1 Cross Point Screw Driver #21 Flat Blade Screw Driver #21 Plastic Oil Bottle1 Handwheel1 Adjustable Wrench1 Operator’s Manual (not shown)1 Warranty Card (not shown)Figure 2: shipping contentsNOTE: If your mill is supplied with an optional Table Powerfeed and/or Digital Readout, be sure to consult theseparate instruction materials that accompany them.