Jet JWBS-10OS Operating Instructions And Parts Manual

Contents

Jet JWBS-10OS Operating Instructions And Parts Manual Manual pdf 13 page image

13Loosen the hex cap screw (G, not visible) witha 10mm wrench and adjust the entire assemblyback or forth to just clear the back of the sawblade. Tighten screw (G), then fine tune theadjustment by repeating the first part of thisstep.6. Secure the roller guide (A) by tightening thethumbscrew (B, upper guide) or setscrew(B, lower guide).Guide Bearing AdjustmentDisconnect machine from thepower source! Never make adjustments withthe machine running! Failure to comply maycause serious injury!Referring to Figure 13:1. Disconnect machine from power source.Note: Blade must already be tensioned and track-ing properly (Adjusting Blade Tension, page 11).2. For the upper blade guide, loosen two thumb-screws (E). For the lower blade guide, loosentwo setscrews (E) with the 3mm hex wrenchprovided.3. Slide the adjustment shaft (F) to position eachroller guide (D) approximately 1/16" behind thegullets of the saw blade.The roller guide (D) is mounted on a concentricshaft (F). When the shaft is rotated, the relativeposition of the guide to the blade can be changed.4. Rotate each adjustment shaft (F) to position theguides (D) within 1/32" of the saw blade.5. Secure the roller guides (D) by tighteningthumbscrews (E, upper guide) or setscrews(E, lower guide).Operating ControlsOn/Off Switch – located on front of machine: pullswitch out to start; push switch in to stop. Whenyellow safety key is removed, machine will notstart.Work Lamp Switch – located on front of machineabove On/Off switch. Turns LED work lamp on andoff.Figure 13