Jet JWBS-20 Owner's Manual
Also see for JWBS-20: Operating instructions and parts manualOperating instructionsOperating instructionsOperating instructions and parts manual
                          | |
Contents
| 
5Contents of Shipping Container1. Bandsaw1. Table1. Fence and Rail Assembly1. Resaw Guide and Knob1. Miter Gauge1. Owner’s Manual1. Warranty Card1. Hardware Package2. Knobs1. Hex Wrench1. Handle1. 10/12mm Wrench1. Fence Hardware Bag4. Hex Cap Screws4. Flat Washers4. Lock Washer1. Rail Hardware Bag9. Hex Cap Screws9. Flat Washers9. Lock WashersUnpacking and Setup1. Remove the crate and packing materialfrom the saw except for the transport skidon the bottom.2. Move the saw to its permanent workinglocation. The site should be dry, well lit, andhave enough room to handle long stock andthe service and/or adjustment of themachine from any side.3. Move the bandsaw off the skid.4. Clean all rust protected surfaces with a mildsolvent or diesel fuel and a soft cloth. Donot use lacquer thinner, paint thinner, orgasoline. These will damage paintedsurfaces.Tools Included for Assembly1. 10/12mm Open End Wrench1. Hex WrenchTools Required for Assembly &Adjustments2. 14mm Open End Wrench1. Cross Point Screw Driver1. Combination Square |
Related manuals for Jet JWBS-20
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine