Jet JWL-1015 Operating Instructions Manual

Also see for JWL-1015: Assembly instructions and parts list Assembly instructions and parts list Operating instructions and parts manual

Contents

Jet JWL-1015 Operating Instructions Manual Manual pdf 6 page image

The specified values are emission levels and are notnecessarily to be seen as safe operating levels.As workplace conditions vary, this information is intended toallow the user to make a better estimation of the hazards andrisks involved only.4.4 Content of deliveryLive centreSpur centreTooling knockout bar150 mm tool rest75 mm face plateOperating manualSpare parts list.Fig 25. Transport and start up5.1 Transport and installationThe machine is designed to operate in closed rooms andmust be placed stable on firm and levelled surface.For safety reasons, the machine must be bolted to the workbench or to the optional stand.Fig 3For packing reasons the machine is not completelyassembled5.2 AssemblyIf you notice transport damage while unpacking, notify yoursupplier immediately. Do not operate the machine!Dispose of the packing in an environmentally friendly manner.Clean all rust protected surfaces with a mild solvent.5.3 Mains connectionMains connection and any extension cords used must complywith applicable regulations.The mains voltage must comply with the information on themachine licence plate.The mains connection must have a10A surge-proof fuse.Only use power cords marked H07RN-FConnections and repairs to the electrical equipment may onlybe carried out by qualified electricians.5.4 Dust collectionUse a suitable dust collection and air filtration system to avoidhigh dust concentrations in the air.5.5 Starting operationYou can start the machine with the green ON-button(D, Fig 4).Fig 4The machine will stop when you push the red OFF button (C).Wait for the workpiece to come to a complete stop.JWL-1015VS only:The variable speeds of the lathe are controlled by the speedcontrol knob (A, Fig 4) as well as the position of the belt onthe pulleys.