Jet JWTS-10 Operating Instructions And Parts Manual

Also see for JWTS-10: Operator's manual

11AssemblyRead and understand allassembly instructions before attemptingassembly! Failure to comply may causeserious injury!Unpacking and Cleanup1. Remove all contents from the shipping carton.Keep the saw table upside down (Figure 1) andplace on a two-by-four or similar piece of woodunder the rear of the saw. This will help whenpicking up the table again. Do not discard thecarton of packing material until the saw isassembled and is running satisfactorily.2. Inspect the contents for shipping damage.Report damage, if any, to your distributor.3. Compare the contents of the shipping cartonwith the contents list in this manual. Reportshortages, if any, to your distributor.Figure 1Stand AssemblyRefer to Figure 2.Tool required – 12mm wrenchMounting Hardware – the stand (excluding wheels)is assembled using 24 each of the following: M8x16carriage bolts (D), M8 flat washers (E), and M8hex nuts (F).The legs consist of one left front leg, one left rearleg and two right legs. The left legs contain thewheel mounting brackets and are not interchange-able. The right legs are interchangeable. Refer toFigure 2 for identification and orientation.1. Assemble the front left and rear left legs (A, B)to a long top plate (C) using the mountinghardware listed above. Hand-tighten only atthis time. The long top plates have no cutouts.Note: For entire assembly place plates inside legs.2. Assemble the right legs (G 1, G 2) to theremaining long top plate (C) in the samemanner.3. Assemble the short top plate with the JET logo(H) to the front stand legs (A, G 1) using thesame combination of hardware as used toattach the long top plates. Hand-tighten thehardware only at this time.4. Assemble the remaining short top plate (J) tothe rear stand legs (B, G 2) in the same manner.5. Assemble two long support plates (K) to theinside of the left stand legs (A, B) and rightstand legs (G 1, G 2) respectively with the samehardware. Hand-tighten only at this time.Note: The long support plates have no cutouts.Figure 26. Assemble two short support plates (L) to theinside of the front stand legs (A, G 1) and rearstand legs (B, G 2) respectively with the samehardware. Hand-tighten only at this time.Note: The short support plates have cutouts.7. Assemble two wheels (M) to the left legs withtwo 3/8”-16 x 2.5” hex cap screws (N) and two3/8”-16 nylon insert lock nuts (O) and tightenwith two 13mm wrenches.8. Place two wheel lock knobs (P) on the bracketsabove the wheels.9. Attach wheel pad assemblies to the right legs(no wheels), each assembly consisting of onethreaded wheel pad (Q), two 5/16" hex nuts (R)and two M8 flat washers (S).