Jet JWTS-10 Operating Instructions And Parts Manual

Also see for JWTS-10: Operator's manual

13HandwheelsReferring to Figure 6:The JWTS-10 Table Saw comes equipped with twohandwheels which look identical except for themounting holes as follows:1. On the front of the table saw slide the bushing(C) onto shaft (D) followed by the handwheel(A) with the larger mounting hole, making sureto line up the flat side in the hole with the flatside on the shaft.2. Fasten in place with lock knob (B).3. Slide the remaining handwheel (D) with thesmaller mounting hole onto the shaft (F) on theright side of the table saw, lining up the flat sidein the hole with the flat side on the shaft.4. Secure with an M5 lock washer (E) and M5x12socket head cap screw (F).Extension WingsReferring to Figure 7:1. Attach the right extension wing (A) to the table(B) on the right side using four M8 hex capscrews (C) and four M8 lock washers (D).Hand-tighten only at this time.2. Repeat for the left side.Rear Guide RailReferring to Figure 8:Required Fastening Hardware:A – 1 ea – Rear Rail (Long)H – 1 ea – Rear Rail (Short)E – 6 ea – Hex Cap Screws (M8x20)F – 6 ea – Lock Washers (M8)G – 6 ea – Hex Nuts (M8)Required Tools:Two 12mm wrenches1. Place the long rail (A) against the back of theright extension (B) and table (C). Line up themounting holes.2. Insert three hex cap screws (E) through therail, extension and table.3. Place lock washers (F) and hex nuts (G) on thethreaded ends of the screws and hand-tightenonly at this time.4. Place the short rail (H) against the back of thetable (C) and left extension (D). Line up themounting holes.Figure 6Figure 7Figure 85. Insert three socket head cap screws (E)through the rail; extension and table.6. Place lock washers (F) and hex nuts (G) on thethreaded ends of the screws and hand-tightenonly at this time.