Jim Chookagian NF3L Installation & Operation Manual
                                | |
Contents
| 
© Published by permission of the copyright owner – DO NOT COPY or TRANSMITInstallation9803623 (EN)NOTE: DO NOT slide washer across floor if theleveling legs have been extended, as legs and basecould become damaged.Remove rubber feet from accessories bag and place onall four leveling legs.Verify that unit doesn’t rock.Figure 4Step 3: Connect Fill HosesWater SupplyWater supply faucets must fit standard 19.1 mm(3/4 inch) female garden hose couplings. DO NOTUSE SLIP-ON OR CLAMP-ON CONNECTIONS.Recommended cold water temperature is 16° to27° Celsius (60° to 80° Fahrenheit). Recommendedmaximum hot water temperature is 51° Celsius(125° Fahrenheit).Models NF3LLFSG401UT06 andNF3LLFSP401UT06: Water pressure must be aminimum of 138 to a maximum of 689 kPa (20 to100 psi) static pressure measured at the faucet.All other models: Water pressure must be a minimumof 138 to a maximum of 827 kPa (20 to 120 psi) staticpressure measured at the faucet.NOTE: Water pressure under 138 kPa (20 psi) willcause an extended fill time in the washer and maynot properly flush out the detergent dispenser.The appliance is to be connected to the water mainsusing new hose-sets and the old hose-sets should notbe reused.FLW2134N1 Leveling Leg2 Washer Base3 Level4 Wood Block5 Locknut6 Rubber FootFLW2134N213564Under certain conditions, hydrogen gasmay be produced in a hot water systemthat has not been used for two weeks ormore. HYDROGEN GAS IS EXPLOSIVE. Ifthe hot water system has not been usedfor such a period and before using thewasher, turn on all hot water faucets andlet the water flow from each for severalminutes. This will release anyaccumulated hydrogen gas. The gas isflammable. Do not smoke or use an openflame during this time. W029WARNINGTo prevent personal injury, avoid contactwith inlet water temperatures higher than51° Celsius (125° Fahrenheit) and hotsurfaces. W750WARNING |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine