Jim Chookagian NF3L Installation & Operation Manual
                                | |
Contents
| 
© Published by permission of the copyright owner – DO NOT COPY or TRANSMITInstallation803623 (EN)14Step 8: Install Appropriate Electrical Plug400 Volt, 50 Hertz, 9.8 AmpNOTE: This washer is factory-wired for a 400 Voltelectrical supply.Have a qualified electrician install appropriateelectrical receptacle.To attach customer-supplied power cord(400 Volt WYE):1. Remove electrical access panel on rear ofmachine.2. Remove plastic plug from hole in rear ofmachine.3. Install strain relief, supplied with machine, inhole.4. Put power cord through hole. Refer to Figure 12.Figure 125. Attach power cord wires as shown in Figure 13.6. Tighten down the strain relief (supplied withunit) on the power cord.7. Reinstall access panel.Figure 13FLW1953N1 Install power cord through this hole afterremoving plastic plug. Use strain reliefsupplied in accessories bag.1FLW1915NNOTE: 1.5 mm2 wire required for 3 phase, 4 wireconnection.1 Black Wire2 Black/White Wire3 Black/Red Wire4 White Wire5 White/Red Wire6 White/Black Wire7 Green/Yellow Wire8 Earth – Power CordL 1 L 2 L 3 N51 2 3 4 68400Volt400Volt400Volt230Volt230VoltTERMINAL BLOCK WIRED FOR 400 VOLT WYEAS VIEWED THROUGH REAR ACCESS PANEL230Volt7 |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine