Kärcher 1105 VAPORAPID Manual

Contents

Kärcher 1105 VAPORAPID Manual Manual pdf 9 page image

95. How to use the accessories• Work on heavily soiled areas at a slowerspeed so that the steam has more time toact on the dirt.• If there are traces of detergent or polish onthe surface that you are cleaning (e.g. wax,liquid polish, etc.), this could result in st-reaks. As a rule these streaks disappear af-ter the steam cleaner has been used sever-al times.Typical applications:– all washable wall and floor coverings, e.g.stone floors, tiles and PVC floors.5.4 Hand nozzle (F1)Pull the terry-towelling slip-on (F2) over thehand nozzle (F1).Typical applications:– smaller, washable areas, such as kitchensurfaces made from plastic, tiled walls– windows, mirrors– furniture fabrics– vehicle interiors, windscreens– bath-tubs5.5 Household iron (K1)• Firmly insert the modular accessory plug onthe iron connecting cable (K5) into the sok-ket (A1) above the handle on the main unit.Both lugs on the plug must lock into the co-ver for the main unit socket (A1).Steam-ironing:• We recommend that you use the KärcherIroning Board with active steam extraction.The ironing board has been designed tomatch your new cleaner and it makes iron-ing considerably easier and faster to do. Inany case, you should use an ironing boardwhich is covered with a mesh-type underlaythat enables steam to pass through.• The temperature control (K4) should be setto at least ••• (steam mode) for ironing alltypes of material. The steam that is then di-scharged prevents the material from beco-ming too hot.• The iron is ready for use as soon as the in-dicator lamp (K3) goes out. The face of theiron must be hot so that the steam does notcondense to water and drip onto the itembeing ironed.• When you press the switch on the iron,steam is discharged out of holes in the faceof the iron. To set the iron so that steam isdischarged continuously, push the switchtowards the rear until it locks in place. If youbriefly push the switch forwards, a shot ofsteam is discharged from the iron.• Begin by directing the steam onto a piece ofcloth until there is regular flow of steam outof the iron.• The iron can be held upright to apply steamto curtains, dresses, etc.Dry-ironing:• If you wish to iron without using steam,switch the heater switch to OFF. The steamsupply switch must remain ON.• Set the temperature control (K4) accordingto the type of fabric that you are going toiron. The symbols on the control have thefollowing meanings:– Synthetic fibres: •– Wool: ••– Linen: •••5.6 Window nozzleThe window nozzle is available as aspecial accessory - see page 12• Before you clean a glass surface with thewindow nozzle for the first time, go over itwith the hand nozzle (F1) and terry-towellingslip-on (F2) to remove any traces of grease.• Apply steam evenly to the glass surface froma distance of approx. 20 cm. When you havedone this, push the locking mechanism onthe steam gun towards the rear (child lock)(C4) so that the steam switch (C3) cannot bepressed inadvertently. Squeegee the glasssurface in straight lines from top to bottom.Wipe the rubber lip and the bottom edge ofthe window dry after each pass.Typical applications:– windows– mirrors– other glass surfaces