Kärcher HD 10/21-4 Cage Original Instructions Manual

Also see for HD 10/21-4 Cage: Manual Manual

– 3Notes about the ingredients (REACH)You will find current information about theingredients at:www.kaercher.com/REACH– Check the contents of the pack beforeunpacking.– In case of transport damage inform ven-dor immediately. Read the oil level display when the de-vice is not running. The oil level must bebetween the two markers on the oil res-ervoir. Cut off tip of oil container coverNote: The EASY!Lock system joins com-ponents with a quick-fasten thread solidlyand securely with just one turn. Insert the high pressure nozzle onto thespray lance. Install union nut and hand-tighten it(EASY!Lock). Join the spray lance with the trigger gunand tighten until hand-tight(EASY!Lock). Join the high-pressure hose with triggergun and high-pressure connection ofthe appliance and tighten until hand-tight (EASY!Lock). WARNINGRisk of injury! Appliance, accessories, sup-ply lines and connections must be in fault-free condition. If they are not in a perfectstate then the appliance must not be used. DANGERDanger of injury by electric shock.– It is imperative to connect the applianceto the electric mains by means of a plug.It is forbidden to permanently connectthe appliance to the power supply. Theplug serves for the disconnection fromthe mains.– The appliance may only be connectedto alternating current.– Minimum fuse strength of the socket(see Technical Data).– The highest allowed net impedance atthe electrical connection point (refer totechnical data) is not to be exceeded. Incase of confusion regarding the powerimpedance present on your connection,please contact your utilities provider.– Use the extension cord that has an ad-equate cross-section (see "TechnicalData") and unwind it fully from the cabledrum.For connection values, see type plate/tech-nical data. WARNINGObserve regulations of water supplier.For connection values refer to technicalspecifications. Connect the supply hose (minimumlength 7.5 m, minimum diameter 3/4“) tothe water connection point of the ma-chine and at the water supply point (fore.g. a tap).Note:The supply hose is not included. Open the water supply.Before StartupUnpackingCheck oil levelActivate deaeration of oil containerAttaching the Accessories2.1.Start upElectrical connectionWater connectionConnection to the water supply13EN