Kärcher HD 3.0/27 G Operator's Manual

Also see for HD 3.0/27 G: Service manual Service manual Service manual Operator's manual Operator's manual

Contents

Kärcher HD 3.0/27 G Operator's Manual Manual pdf 8 page image

• 9.801-759.0 • Rev. 11/15OPERATOR’S MANUAL PRESSURE WASHER8STEP 1: Attach the high pressurehose to the spray gun using tefl ontape on hose threads.STEP 4: Release the coupler collarand push the nozzle until the collarclicks. Pull the nozzle to make sureit is seated properly.STEP 5: Connect the high pressurehose to the discharge nipple. Pushcoupler collar forward until secure.STEP 2: Attach wand to spray gunusing teflon tape on wand threads.STEP 3: Pull spring-loaded collarof the wand coupler back to insertyour choice of pressure nozzle.STEP 6: Connect garden hose tothe cold water source.STEPS 8 and 9 for Electric Start Machines Only ( HD 4.0/40 Ge and HD 4.0/40 GeB)ASSEMBLY INSTRUCTIONSSTEP 7: Check inlets filters, re-move debris, then connect thegarden hose to pump water inlet.CAUTION: Do not run the pumpwithout water or pump damagewill result.STEP 8: Place battery in battery box. Use a standard12 volt battery.STEP 9: To reduce the possi bili ty of sparking attach thewires to the battery in the following order.Refere toimage aside. First attach the red wire to the positive “+"terminal of battery and the black wire to the negative“-" terminal of the battery.To disconnect the batteryremove the wires in the opposite order as installed.Install battery box cover and fasten in place.SafetyLatchSprayGunHighPressure HoseWandSprayGun/WandWandCouplerPressureNozzlePressureNozzleWandCouplerCouplerCollarDischargeNippleHighPressureHoseColdWaterSourceGardenHosePumpWater InletGardenHoseCoupler CollarBox StrapBatteryBox LidRed Wire From themotor starter12 VoltBatteryBatteryTerminalBattery BoxBlack Wire Fromground