Kärcher HD 4/9 P Original Instructions Manual

Also see for HD 4/9 P: Manual Manual

Contents

– 3Note: The EASY!Lock system joins com-ponents with a quick-fasten thread solidlyand securely with just one turn. Insert the high pressure nozzle onto thespray lance. Install union nut and hand-tighten it(EASY!Lock). Join the spray lance with the trigger gunand tighten until hand-tight(EASY!Lock). Join the high-pressure hose with triggergun and high-pressure connection ofthe appliance and tighten until hand-tight (EASY!Lock). WARNINGRisk of injury! Appliance, accessories, sup-ply lines and connections must be in fault-free condition. If they are not in a perfectstate then the appliance must not be used. DANGERDanger of injury by electric shock.– It is imperative to connect the applianceto the electric mains by means of a plug.It is forbidden to permanently connectthe appliance to the power supply. Theplug serves for the disconnection fromthe mains.– The plug and coupling of the extensioncable used must be watertight.– Use an extension cable with protectiveearth conductor (protection class 1) andan adequate cross section (see "Tech-nical data") und fully uncoil it from thecable drum.For connection values, see type plate/tech-nical data. Unwind the mains cable and place it onthe floor. Insert the mains plug into a socket. WARNINGObserve regulations of water supplier.According to applicable regula-tions, the appliance must never beused on the drinking water netwithout a system separator. A suit-able system separator by KÄRCHER or al-ternatively a system separator according toEN 12729 type BA must be used.Water that was flowing through a systemseparator is considered non-drinkable. CAUTIONAlways connect the system separator tothe water supply, never directly to the appli-ance!For connection values refer to technicalspecifications Connect the supply hose (min. length 7.5m, minimum diameter 1/2“) to the waterconnection point of the machine and atthe water supply point (for e.g. a tap).Note:The supply hose is not included. Open the water supply. Screw the suction hose with filter (op-tional accessory) to the water connec-tion. Appliance ventilation:Unscrew the nozzle from the spraylance.Switch on the appliance and let it rununtil the water exiting is bubble-free.Let the appliance run for 10 seconds –then switch off the appliance switch.Repeat the procedure several times. Switch off the appliance and fit the noz-zle again.Before StartupAttaching the AccessoriesStart upElectrical connection2.1. Water connectionConnection to the water supplyDrawing in water from open reservoirs15EN