– 4 DANGERRisk of explosion!Do not spray flammable liquids.If the appliance is used in hazardous areas(e.g. filling stations) the correspondingsafety regulations must be observed.Risk of injury! Hold the hand spray gun andthe spray pipe firmly with both hands.Risk of injury! The trigger and safety levermay not be locked during the operation.Risk of injury! Contact Customer Service ifthe safety lever is damaged.Risk of injury from high-pressure water jet.Slide the safety catch on the trigger gun for-ward before performing any work with theappliance. CAUTIONEnvironmental damage. Clean motors at plac-es with a corresponding oil separator only. To open the trigger gun: Actuate thesafety lever and trigger. To close the hand spray gun: Releasethe safety lever and trigger.The appliance can be operated in a verticalor horizontal position.Note:The appliance is equipped with a pressureswitch. The motor starts up only when thetrigger gun is open. Set the appliance switch to "I". Release the trigger gun. To do so, pushthe safety catch towards the back. Open the hand spray gun. Close the hand spray gun.The appliance switches off. Secure the trigger gun. To do so, pushthe safety catch towards the front.After the interruption: Release the trigger gun. To do so, pushthe safety catch towards the back. Open the hand spray gun.The appliance will switch on again. Shut off water supply. Open the hand spray gun. Switch on the pump with the powerswitch and allow to run for about 5-10seconds. Close the hand spray gun. Set the appliance switch to "0/OFF“. Pull main plug out of socket with dryhands only. Remove water connection. Activate hand spray gun until device ispressure less. Secure the trigger gun. To do so, pushthe safety catch towards the front. Place the spray lance with the triggergun into the quiver for the spray lanceand snap it into place in the spray lanceholder. Wind the connection cable around thecable holder. Fasten the plug with the mounted clip. Slide in push handle. Wind up the high-pressure hose andhang it over the hose storage.ATTENTIONFrost will destroy the not completely waterdrained device.Store the appliance in a frost free area. Drain water. Pump in conventional frost protectionagents through the appliance.Note:Use normal glycol-based anti-freezingagents for automobiles.Observe handling instructions of the anti-freeze agent manufacturer. Operate device for max. 1 minute untilthe pump and conduits are empty.OperationOpening/closing the trigger gunOperationInterrupting operationTurn off the applianceStoring the ApplianceFrost protectionIf you cannot store it in a frost-freeplace:16 EN

symbols on the machine

water connection

Kärcher HD 4/9 P Original Instructions Manual