Kärcher HD 6/13 ST Manual

Contents

Kärcher HD 6/13 ST Manual Manual pdf 14 page image

– 2High-pressure jets can be dan-gerous if improperly used. Thejet may not be directed at per-sons, animals, live electrical equipment orat the appliance itself.Use this high pressure cleaner exclusivelyfor– Cleaning using low pressure jet and de-tergent (for e.g. for cleaning machines,cars, buildings, tools),– For cleaning using high pressure jetwithout detergent (for e.g. for cleaningfacades, terraces, garden appliances).For stubborn dirt, we recommend the use ofthe dirt blaster as a special accessory.Safety devices serve for the protection ofthe user and must not be put out of opera-tion or bypassed with respect to their func-tion.– While reducing the water supply/quanti-ty regulation at the pump head, theoverflow valve opens and part of thewater flows back to the pump suck side.– If the lever on the trigger gun is releasedthe pressure switch turns off the pump,the high-pressure jet is stopped. If thelever is pulled the pump is turned onagain.The overflow valve and pressure switch areset and sealed at the factory. Setting onlyby customer service.– Check the contents of the pack beforeunpacking.– In case of transport damage inform ven-dor immediately– Store the drilling template on the cartonto assemble the device.CautionRisk of injury and damage! Note the weightof the appliance during installation.The enclosed fastener is not suitable forfastening to concrete walls.Risk of damage! Freezing water in the ap-pliance can destroy parts of the appliance.The machine should be stored in frost-freerooms. In case there is frosting risk, for e.g.if the machine is installed in open areas,then the machine must first be emptied andflushed using an anti-freezing agent.vÎ Check the wall's support capacity.Î Drill 2 holes of 10 mm diameter into thewall using the drilling template on thepackaging.Î Insert the enclosed heavy load dowelinto the holes.Î Remove side panels.Î Hang up the appliance and secure itagainst falling down.Î Tighten the nuts of the heavy load dowel.Î Replace side panels.Î Loosen the fastening screws, removethe hood.Î Cut off tip of oil container coverÎ Check oil level in the oil tank.Î Fasten the hood.Î Mount the nozzle on the spray pipe (mark-ings on the adjustment ring at the top).Î Connect ray tube to hand spray gunÎ Lever out the safety clip of the handspraygun using a screw-driver (Picture A).Î Place the hand-spray gun upside downand insert the end of the high pressurehose till the end. Ensure that the losedisc falls right below on the hose end(Picture B).Î Press the safety clip back into the hand-spray gun. The hose can be pulled outmax. 1 mm if it has been installed cor-rectly. Otherwise, it means the disc hasbeen installed wrongly (picture C).Symbols on the machineProper useSafety DevicesOverflow valve with pressure switchBefore StartupUnpackingFasten the device to the wallCheck oil levelAttaching the Accessories14 EN