Kärcher HDS 13/20-4 S/SX Instructions Manual

Also see for HDS 13/20-4 S: Original instructions Manual Manual Manual Instructions

Contents

Kärcher HDS 13/20-4 S/SX Instructions Manual Manual pdf 28 page image

– 6 Route the new high-pressure hosethrough the intended hose guide andthe deflection pulley at the bottom of theappliance. Slide the hose nipple all the way into theknot section of the hose drum and se-cure with the fastening clamp. Replace the half bowl.For connection values refer to technicalspecifications Attach supply hose (minimum length7.5 m, minimum diameter 3/4“) to thewater supply set by means of a hoseclamp. Connect the supply hose to the waterconnection point of the machine and atthe water supply point (for e.g. a tap).Note: The supply hose and the hose clampare not included in the scope of delivery.If you want to suck in water from an exter-nal vessel, the following modification isnecessary:Figure 8 Remove water connection from thepump head. Unscrew the upper supply hose to theswimmer container at the fine filter andconnect it to the pump head. Replug the rinse line of the detergentdosing valve. Connect suction hose (minimum diame-ter 3/4“) with filter (accessory) to thewater connection point.– Max. suck height: 0.5 mUntil the pump sucked in water, you should: Set the pressure/quantity regulation atthe pump unit to maximum quantity. Close the dosing valve for the deter-gent. DangerNever suck in water from a drinking watercontainer. Never suck in liquids which con-tain solvents like lacquer thinner, petrol, oilor unfiltered water. The sealings within thedevice are not solvent resistant. The spraymist of solvents is highly inflammable, ex-plosive and poisonous.– For connection values, see technicaldata and type plate.– The electrical connections must bedone by an electrician according to IEC60364-1. DangerDanger of injury by electric shock.– Unsuitable electrical extension cablescan be hazardous. Only use electricalextension cables outdoors which havebeen approved and labelled for this pur-pose and have an adequate cablecross-section.– Always unwind extension lines com-pletely.– The plug and coupling of the extensioncable used must be watertight.CautionThe highest allowed net impedance at theelectrical connection point (refer to techni-cal data) is not to be exceeded. In case ofconfusion regarding the power impedancepresent on your connection, please contactyour utilities provider. DangerRisk of explosion!Do not spray flammable liquids. DangerRisk of injury! Never use the appliancewithout the spray lance attached. Checkand ensure proper fitting of the spray lanceprior to each use. The screw connection ofthe spray lance must be fingertight.Water connectionSuck in water from vesselPower connectionOperation28 EN