Kärcher HDS 3.5/23-4M Eg Manual
Also see for HDS 3.5/23-4M Eg: Operating instructionsManual
                                                            | |
– 5 DANGERDanger of explosion! Only refill diesel oil orlight fuel oil. Inappropriate fuels, e.g. petrol,must not be used.ATTENTIONRisk of damage! Never operate device withan empty fuel tank. The fuel pump will oth-erwise be destroyed. Refill fuel. Close tank lock. Wipe off spilled fuel. DANGERRisk of injury!– Use Kärcher products only.– Under no circumstances fill solvents(petrol, aceton, diluting agent etc.)– Avoid eye and skin contact.– Observe safety and handling instruc-tions by the detergent manufacturer.Kärcher offers an individual cleaningand care appliances program.Your dealer will consult you gladly. Refill detergent.Note: The EASY!Lock system joins com-ponents with a quick-fasten thread solidlyand securely with just one turn.Figure 5 Join the spray lance with the trigger gunand tighten until hand-tight(EASY!Lock). Insert the high pressure nozzle onto thespray lance. Install union nut and hand-tighten it(EASY!Lock). Join the high-pressure hose with triggergun and high-pressure connection ofthe appliance and tighten until hand-tight (EASY!Lock).For connection values refer to technicalspecifications. Attach supply hose (minimum length24.6 ft/7.5 m, minimum diameter 3/4“)to the water supply set by means of ahose clamp. Connect the supply hose to the waterconnection point of the machine and atthe water supply point (for e.g. a tap).Note: The supply hose and the hose clampare not included in the scope of delivery.If you want to suck in water from an exter-nal vessel, the following modification isnecessary:Figure 6 Open fill opening for system care. Release and remove the cover of thesystem care. Remove water connection from the finefilter. Unscrew the fine filter from the pumphead.Figure 7 Remove the system care reservoir. Unscrew the top supply hose to theswimmer container.Figure 8 Connect the top supply hose at pumphead. Replug the rinse line of the detergentdosing valve. Connect suction hose (minimum diame-ter 3/4“) with filter (accessory) to thewater connection point.– Max. suck height: 1.6 ft (0.5 m)Until the pump sucked in water, you should: Set the pressure/quantity regulation atthe pump unit to maximum quantity. Close the dosing valve for the detergent.Refill fuelRefill detergentInstall the hand-spray gun, the jetpipe, the nozzle and the highpressure hoseWater connectionSuck in water from vessel12 EN |
Related manuals for Kärcher HDS 3.5/23-4M Eg
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine