Kärcher HDS 3.5/23-4M Eg Manual

Also see for HDS 3.5/23-4M Eg: Operating instructions Manual

Contents

– 10 Take out sieve. Clean sieve in water and reinstall. Unpressurize the appliance. Unscrew the fine filter from the pumphead. Remove the fine filter and the filter in-sert. Clean the filter with clean water or com-pressed air. Reinstall in reverse sequence. Loosen covering nut and take off hose. Take out sieve.Note: If necessary turn in screw M8 appr.0.2 in/5 mm inwards and therewith pull outsieve. Clean sieve in water. Push sieve inwards. Put on hose. Tighten covering nut firmly. Take out detergent suck supports. Clean filter in water and reinstall. Ready a catch bin for appr. 0.26 gal/1 Liter oil. Loosen release screw. Tighten release screw. Fill oil slowly up to the MAX marking.Note: Air pockets must be able to leak out.For oil type refer to technical specifica-tions. DANGERRisk of injury by inadvertent start-up of ap-pliance and electric shock. Prior to all workon the appliance, switch off the applianceand pull the power plug.– Lack of oil Replenish oil.– Leak in the high pressure system Check high pressure system and con-nections for tightness.– Water shortage Check water supply, check connections.– Obstructed reed switch in the watershortage safe guard. Check water shortage safe guard.– No line voltage, see "Appliance is notrunning".– Contactor error Set the appliance switch to "0/OFF“. Turn on the appliance.– Error occurs repeatedly. Inform Customer Service.– Engine overload/overheat Set the appliance switch to "0/OFF“. Allow device to cool down. Turn on the appliance.– Error occurs repeatedly. Inform Customer Service.– Fault in the voltage supply. Check main connections and mainsfuse.– Excessive power consumption. Check main connections and mainsfuse. Inform Customer Service.Maintenance WorksClean the sieve in the water connectionCleaning the fine filterClean sieve in the water shortage safeguardClean filter at the detergent suck hoseOil changeDispose of old oil ecologically or turn in ata gathering point.TroubleshootingIndicator lamp pump1x blinking2x blinking3x blinking4x blinkingIndicator lamp "Ready for use"turns offEngine indicator lamp1x blinking2x blinking3x blinking4x blinking17EN