– 6 Replace the high-pressure nozzle withsteam nozzle (refer "Using steam").Servo pressure regulation: Set device switch to max. 98 °C.Figure 6 Set regulating spindle to maximumworking pressure.Figure 5– Set working pressure and flow ratethrough turning (directly) at the pres-sure- and amount regulation (B) of thehandgun (+/-). DangerWhen adjusting the pressure/quantity regu-lation, make sure that the screw connectionof the spray lance does not become loose.Note: For long term work with low pres-sure, set pressure at device.See Figure 6.– For considerate treatment of the envi-ronment use detergent economically.– The detergent must be suitable for thesurface to be cleaned. With support of the detergent dosevalve set detergent concentration asdetermined by the manufacturer.0 = work without detergentNote: Recommended values at the controlpanel at maximum working pressure. Set pressure/temperature and deter-gent concentration according to the sur-face to be cleaned.Note: To prevent damage due to too muchpressure, always position high pressure rayfirst from a greater distance towards objectto be cleaned.The spray angle is essential for the effec-tiveness of the high pressure ray. Normallywork is performed with a 25° flat ray nozzle(included).Recommended nozzles are deliverable asaccessories– For strong contaminations0° full ray - nozzle– For sensitive surfaces and light contam-inations40° flat ray - nozzle– For thick layered, persistent contamina-tionsDirt grinder– Nozzle with adjustable spray angle, foradaption to different cleaning tasksAngle-Vario-Nozzle– Loosen the dirt: Spray detergent economically and let itwork for 1...5 minutes but do not let itdry up.– Remove the dirt: Spray off loosened dirt with the high-pressure jet.Removal of light contaminations and clearrinse, i.e.: Gardening tools, terrace, tools,etc. Set operating pressure according toneed. Set the appliance switch to "I".Set working pressure and flow rateOperation with detergentDose adjustment Concentration1 0,25 %2 1,00 %3 1,25 %4 1,50 %5 1,75 %6 2,00 %CleaningWorking with the high pressure nozzleRecommended cleaning methodOperating with cold water24 EN