Kärcher HDS Super SX Operating Instructions Manual

Also see for HDS 1195 SX Eco: Operating instructions Instructions

Kärcher HDS Super SX Operating Instructions Manual Manual pdf 25 page image

Operating Instructions HDS Super SX/HDS 695 SX/HDS 895 SX/HDS 1195 SX English25Mains connectionRefer to technical data and rating plate forconnected loads.Warning!Whenever socket is changed, checkdirection of rotation of motor— If direction of rotation is correct, powerfuljet of air will be felt at exhaust-gasopening of burner.— If direction of rotation is wrong:interchange terminals at unit plug. SeeFigure 17.! When an extension cable is used itshould always be complety unwoundand have an adequate cross-section.OperationWarning! (Only HDS Super SX)Lengthy operation of the unit can lead tovibration-related circulatory disturbances ofthe hands.It is not possible to specify a generallyapplicable use duration, since this isdependent and influenced by a number offactors:— Personal predisposition to badcirculation (frequent suffering from coldfingers, pins and needles in fingers).— In low ambient temperatures. Wearwarm gloves to keep hands warm.— Gripping tightly impedes circulation.— Continuous operation is moredetrimental than operation interrupted bybreaks.We recommend a medical examination ifthe unit is regularly used for extensive,continuous operation and thecorresponding symptoms (such as, forexample, pins and needles in fingers orcold fingers) are recurrent.Switch on the machine! Set the unit switch (item 23) to "I"Ready for working indicator lamp (item28)is litWarning!The temperature regulator (item 24) mustbe at setting "0", since it is otherwisepossible that the burner switches itself onUnit starts up briefly and is switched off assoon as operating pressure is reached.Shut down unit immediately if indicatorlamp (item25-27) lights up during operation.Eliminate fault, refer to Faults.Figure 9! Release handgunActuation of handgun switches unit back onagain.Bleed pump if no water emerges from high-pressure nozzle. Refer to Faults "No build-up of pressure by unit"Setting cleaning temperature! Set the temperature regulator (item 24)to the required temperature30°C to 90°CHot water cleaning100°C to 150°CClean with steam, with steam nozzle- 4.766-023 (HDS Super SX /HDS 695 SX / HDS 895 SX)- 4.766-024 (HDS 1195 SX)