Kärcher K 2.400 Operating Instructions Manual

Also see for K 2.400: Manual Operating instructions

Contents

English 7Assemble appliance as shown on page 6Mount loose parts delivered with applianceprior to start-up.Illustration Insert the transport wheels and lockthem.Illustration Attach the transport handle /carryinghandle.Illustration Fasten the quick coupling for the highpressure hose to the high pressure con-nection.Illustration Push the high pressure hose into thetrigger gun until it locks audibly.Note: Make sure the connection nippleis aligned correctly. Check the secure connection by pullingon the high pressure hose.Illustration Pull the suction hose for detergentthrough the cover of the detergent tankuntil the filter contacts the bottom of thetank. Close the detergent tank with the lid. Lock the detergent tank in place on theappliance.According to the applicable regula-tions, the appliance must never beused on the drinking water supplywithout a system separator. Use asuitable system separator manufactured byKÄRCHER; or, as an alternative, a systemseparator as per EN 12729 Type BA. Waterflowing through a system separator is con-sidered non-drinkable.CautionAlways connect the system separator to thewater supply, never directly to the appliance!Note: Impurities in the water can damagethe high-pressure pump and accessories.For protection, the use of the KÄRCHERwater filter (optional accessory, order no.4.730-059) is recommended.Observe regulations of water supplier.For connection values, see type plate/tech-nical data. Use a fibre-reinforced water hose (notincluded) with a standard coupling.(Minimum diameter 1/2 inch (13 mm),minimum length 7.5 m).Illustration Screw the coupling element to the wa-ter connection on the appliance. Push the water supply hose onto thecoupling unit, then connect it to the wa-ter supply.KÄRCHER recommends using the suctionhose accessory (sold separately) Order no.9.505-779.0.STEP 1: Connect the suction hose to the waterinlet on the pressure cleaner and dropthe other end into a bucket.Tip: If you are not using this accessory, coila hose into the bucket and ensure that youonly use a standard hose clamp to connectto the pressure washer.CLICK FITTINGS MUST NOT BE USED!STEP 2: Fill up your bucket with water.STEP 3: Connect the KÄRCHER power cord toan electricity source and turn on at pow-Before StartupWater supplyWater supply from mainsHow to draw water from a bucket whenusing a KÄRCHER Pressure Cleaner