English 5 Make sure that the power cable or ex-tension cables are not damaged by run-ning over, pinching, dragging or similar.Protect the power cable from heat, oil,and sharp edges. The connection between the power cableand extension cable must not lie in water. All current-conducting parts in the work-ing area must be protected against jetwater. The appliance may only be connectedto an electrical supply which has beeninstalled in accordance with IEC 60364. The appliance may only be connectedto alternating current. The voltage mustcorrespond with the type plate on theappliance. The minimum fuse rating required at thesocket outlet is 13 A (slow-blow). To avoid accidents due to electricalfaults we recommend the use of sock-ets with a line-side current-limiting cir-cuit breaker (max. 30 mA nominaltripping current). The plug and coupling of the extensioncable used must be watertight. Always fully unroll electrical cables fromthe cable drum. This appliance was designed to beused with detergents which are sup-plied or recommended by the manufac-turer. The use of other detergents orchemicals may compromise the safetyof the appliance.Safety devices serve to protect the userand must not be rendered inoperational ortheir functions bypassed.The switch prevents unintented starting ofthe appliance. Stop the appliance duringbreaks or after operation.The safety catch on the trigger gun pre-vents the appliance from being switched onunintentionally.The high pressure hose is specially con-structed with reinforced walls to handle wa-ter pressure up to 16 MPa (2700 psi) - it iseasily damaged and should be stored care-fully. Do not kink. Do not drive vehicles over the hose. Do not expose the hose to sharp edgesor corners.Misuse will lead to ballooning or prematurefailure and will invalidate warranty.Î Assemble appliance as shown onpage 10.Î Push out the safety clip in the triggergun using e.g. a small screwdriver.Î Join high pressure hose and trigger guntogether.Î Push clip in until it engages and checkthat it is securely fastened by pulling onthe high pressure hose.The appliance is not suited for usein the drinking water supply net-work. It is necessary to install asuitable system separator fromKärcher, if the device is to be used in thedrinking water supply network.For connection values, see type plate/tech-nical data.Observe regulations of water supplier.Î Use a fibre-reinforced hose (not includ-ed) with a standard coupling:- Minimum diameter, 1/2 inches(13 mm)- Minimum length, 7.5 m.Î Screw the coupling unit (supplied) tothe water connection on the appliance.Î Push the water supply hose onto thecoupling unit, then connect it to the tap.Safety DevicesPower switchSafety catchHigh pressure hoseCommissioning and operationBefore StartupWater supplyWater supply from mains